Q: It's about the break pad assembly kit
I'm having trouble getting the clips that came with my rear break pads to stay on the pad
The statements expressed above are only for informational purposes and should be independently verified. Please see our
terms of service
for more details
Get an instant quote for your car
Our certified mechanics come to you ・Backed by 12-month, 12,000-mile guarantee・Fair and transparent pricing
What others are asking
Lost first and second gear
Due to the design of this vehicle it is common for the shift linkage connecting bushings to fail because they rot out and bind until they come apart. When this occurs the shifter cannot properly move the shift mechanism inside...
Clutch won't engage
Sounds like the clutch disc has been burned out. You will need to replace the clutch, pressure plate, and release bearing. Have the vehicle serviced by a certified mechanic, they will be able to diagnose and fix your clutch issue...
car will crank but won't turn over
Listen for the fuel pump to come on for 2 seconds when you turn the key on. You may have to listen back by the fuel tank. Check for coolant level to be low. You may have a cracked upper...
My air is blowing cold-hot-cold-hot-cold-hot...
It is possible that you have a leak in the AC system (https://www.yourmechanic.com/services/coolant-is-leaking-inspection). There are pressure switches that will turn off the compressor if the pressure is too high or too low. The low refrigerant level could cause the AC...
Where is the ignition switch harness located? Also, what color wire and gauge are the ignition accessory wires for this vehicle?
Hi and thank you for contacting YourMechanic about your backup camera installation (https://www.yourmechanic.com/article/how-to-buy-a-good-quality-back-up-camera-system). The ignition switch harness is located inside the steering wheel column on the left side. If I'm not mistaken, the ACC wire will be an 18 gauge...
The other day I had just parked and turned off my car then about 10 minutes later I went to start it and it shook and stalled
Every engine needs three things to start and run. Spark, air, and fuel. Unless the air intake is restricted, air is almost always present. If spark and/or fuel are missing, the vehicle will not run. Lack of spark can be...
Oil is green in color.
Hi there. Diesel fuel has a green tint to it. It is possible that the fuel has gotten into the oil, but most likely the diesel will just thin out the oil. If the oil if light bright green in...
Truck is back-firing.
There are a few possible causes for an engine to backfire (https://www.yourmechanic.com/services/engine-is-backfiring-inspection). Some of the more common causes are a vacuum leak, lean condition caused by a weak fuel pump, an exhaust manifold leak, or a faulty ignition system. With...
My car is shaking at idle and is losing power in the low end service engine soon light is flashing.
Engine misfires can be caused by many different problems and are generally caused by either a spark or fuel issue or in some cases, a combination of both. Spark related problems generally will result from things like ignition coils, crankshaft...
Related articles
How Disc Brakes Work
Car disc brake systems are made up of the rotor, brake pads, pistons, and caliper. The pistons push the pads into the rotor to slow or stop your car.
Symptoms of Bad or Failing Brake Pads
If your brakes are noisy, the brake pedal is pulsating, or the brakes are responding poorly, you may need to replace the brake pads.
3 Ways to Increase the Average Life of Car Brakes
Car brakes are essential to safe driving. Extend the life of your brakes with soft braking, coming to a complete stop, and removing excess weight.
Browse other content
Cities
Maintenance
Estimates