Q: I hear a cluck when I let off the gas.

Hello! That is an issue that many owners of your specific vehicle have faced. The issue is caused by the harness in the door being a little to short and when you open the door it literally pulls the wires...

Hello there, thank you for asking about your 1991 Geo Storm. After your comment about flooding the parking lot with steam, this symptom leads me to believe you may have a failed head gasket. A failure in this seal will...

You may have gotten a defective oil filter. I would not try and run the motor until you replace the filter again. Once it is replaced then start and run engine for a minute or less to see if it...

Hi there. Check all of the cooling hoses (https://www.yourmechanic.com/services/radiator-hose-replacement) on the engine, to the heater core, and to the radiator. See if any hoses are cracked. Check to see if the clamps are loose and need tightened or replaced. Look...

Hello - your Toyota does not have a timing belt that requires replacement periodically. It has a timing chain (https://www.yourmechanic.com/article/how-long-does-a-timing-chain-last), lubricated by engine oil, that lasts for much longer. Changing your engine oil and filter regularly is your best maintenance...

The interior illumination through the head light dimmer control should be checked that the dimmer is turned to its brightest setting when the lights are on. If so then the light switch power supply for dimmer control needs replaced. If...

Hi there. If you download our mobile app, you can set up an automatic updates when all services are due. However, if you live outside the United States, we're not able to provide you with repair or maintenance solutions. You...

If gasoline was left in the fuel tank for more than 3-6 months, the tank would have to be thoroughly drained. Old gas will NOT start an engine. The fuel filter should be replaced as well. If the car has...

The P0746 code (https://www.yourmechanic.com/article/p0746-obd-ii-trouble-code-pressure-control-solenoid-performance-or-stuck-off-by-valerie-johnston) will set if the PCM detects an irregularity in the electronic pressure control solenoid circuit. Typically, that means that the level of hydraulic pressure (in PSI) commanded or expected is not actually detected by the computer....