Q: Q: How do I use the lane change signals?

asked by on

How do I use the lane change signals?

Lane change signals alert your surrounding freeway drivers of your intention to change lanes. They are the same as turn signals, but they go off automatically after a short amount of time. To use the lane change signals, locate the turn signal lever, on the left side of the steering column. Pull the lever up to the right detent and immediately release to signal a right lane change, or push the lever down and immediately release to signal a left lane change.

Was this answer helpful?

Need advice from certified mechanic? Get help now!

Over 1,000 mechanics are ready to answer your question.
The statements expressed above are only for informational purposes and should be independently verified. Please see our terms of service for more details

Ask a Mechanic
(100% Free)

Have a car question? Get free advice from our top-rated mechanics.

Ask A Mechanic
Over 10,000 questions answered!
  1. Home
  2. Questions
  3. Q: How do I use the lane change signals?

Get an instant quote for your car

Our certified mechanics come to you ・Backed by 12-month, 12,000-mile guarantee・Fair and transparent pricing

Get a quote

What others are asking

Q: Do you think 1,183 a good price for front lower control arms?

Hi there. It really depends on what is being replaced and if this service includes a front end alignment. If the lower control arm is the only part that is being replaced, and no suspension alignment is being completed, this...

Q: The turn signal is working intermittently

The combination switch relies on the signal/flasher relay for power. This relay controls both the signal lights and the hazard lights. The relay itself can be at fault even if the hazard lights are working properly. If the relay is...

Q: Shift to 'P' range display on dash.

Hi there. The transmission position sensor may be damaged or has a short inside the sensor. Check the harness to the sensor and make sure that it's hooked up properly and has no moisture in it. If the harness is...

Related articles

P0052 OBD-II Trouble Code: HO2S Heater Control Circuit High (Bank 2 Sensor 1)
P0052 code definition HO2S Heater Control Circuit High (Bank 2 Sensor 1) What the...
Rules of the Road For Iowa Drivers
Driving on the roads requires knowledge of the rules, many of which are based on common sense and courtesy. However, even though you know the rules in...
P2428 OBD-II Trouble Code: Exhaust Gas Temperature Too High Bank 1
P2428 code definition A P2428 trouble code signifies that the PCM has detected a problem in the exhaust gas temperature sensor circuit in bank 1, which subsequently contains the number one...