Q: How do I set park lock mode?

asked by on

How do I set park lock mode?

When your car is in park lock mode, all of the doors and the trunk will automatically lock when you depress the brake pedal and shift your vehicle out of P. You can manually set park lock mode with a few easy steps: 1. Engage the parking brake. 2. Make sure that the shifter is in the P position. 3. Make sure that the driver’s door is closed. 4. Turn the ignition to On. 5. Press the lock button on the master door lock switch (located on the driver’s door), and hold until you hear two clicks. This should take at least five seconds. 6. Turn the ignition to ACC. This step will need to be done within 20 seconds of step 5.

Was this answer helpful?
The statements expressed above are only for informational purposes and should be independently verified. Please see our terms of service for more details
  1. Home
  2. Questions
  3. How do I set park lock mode?

Get an instant quote for your car

Our certified mechanics come to you ・Backed by 12-month, 12,000-mile guarantee・Fair and transparent pricing

Get a quote

What others are asking

Q: What does the Front Camera Blocked, Clean Windshield message mean?

The Front Camera Blocked, Clean Windshield message can appear in the driver information center (DIC). When the DIC displays this alert, it means that the front camera sensor is blocked, and both the Lane Departure Warning (LDW) and Forward Collision...

Q: Dropped a 10 mm wrench inside the engine compartment.

You may not have any worries unless the wrench gets in a place where it makes noise or interferes with vehicle components. The wrench may have fell into the inner fender. You may be able to locate it there. Have...

Q: I have a 2012 hyundai accent and the transmission shakes and rumbels in park, neutral, and reverse and sits fine in drive.

Hi there. There could be an issue within the transmission making the inside parts vibrate in neutral and under a reverse load. Also, there could be a transmission mount issue causing the transmission to shake, but when the vehicle is...

Related articles

How Long Does a Distributor O Ring Last?
The distributor is part of the ignition system in your vehicle and its purpose is to route high voltage from the ignition coil to the spark plug. The spark plug then...
Rules of the Road For Iowa Drivers
Driving on the roads requires knowledge of the rules, many of which are based on common sense and courtesy. However, even though you know the rules in...
P2428 OBD-II Trouble Code: Exhaust Gas Temperature Too High Bank 1
P2428 code definition A P2428 trouble code signifies that the PCM has detected a problem in the exhaust gas temperature sensor circuit in bank 1, which subsequently contains the number one...