Q: How do I install a head restraint?

asked by on January 07, 2016

How do I install a head restraint?

The front head restraints, and the rear center head restraint can be removed. After being removed, these head restraints will need to be reinstalled. Installing one of the head restraints takes only a few seconds: 1. Insert the head restraint legs into the locks. 2. Press and hold the release button, which is located at the base of the head restraint’s legs. 3. Push the head restraint down to the desired height, then let go of the release button. 4. Try and move the head restraint to make sure that it is securely locked into place.

The statements expressed above are only for informational purposes and should be independently verified. Please see our terms of service for more details

Get an instant quote for your car

Our certified mechanics come to you ・Backed by 12-month, 12,000-mile guarantee・Fair and transparent pricing

What others are asking

where is the ecm control modu

The ECM is located behind the left front wheel well cover splash cover.

Thumping noise when turning

What you are describing sounds like a wheel bearing that may be starting to fail. A wheel bearing will usually fail due to pitting or small damage on the surface of the rollers or the bearing race. Both the surface...

How do I open the RamBox side storage units?

The RamBox side storage units allow you to have extra storage in the bed of your truck. The storage boxes are on both sides of the bed of the truck, and offer protected and waterproof storage space. To open the...

How do you pair a cell phone with the HandsFreeLink system?

In order to make use of the convenience and enhance safety offered by the HandsFreeLink® (HFL) system in your car, you’ll need to first pair your phone. Thankfully, doing so is relatively straightforward. Here’s how to do it: Make...

Check engine and VSA light is on and car is shaking at stops

Hello there. Many different faults will cause your check engine light to flash and VSA light to be on with your 2007 Honda CRV. When the check engine light is flashing this is indicating that a fault has the potential...

No sound from speakers but the dash panel works

Hi, thanks for writing in. This is likely an issue with the audio control module which controls the output to speakers and any pre-amp controls. I recommend having one of our certified automotive technicians from YourMechanic come to your home...

Car makes noise like howling wind while Idling.

The power steering pump may whine if the fluid level has become too low from a leak or you may hear a squealing noise if the belt has become too slack. While the belt is off would be a good...

How do I change the ringtone?

The incoming call ringtone can be chosen from three available tones. To listen to and select the different ringtones, follow these steps: Press the Setup button. Press phone, phone sound settings, ring tone, then choose the tone you'd like....

SRS airbag light on

Hello! An airbag light will usually set due to a fault in the SRS circuit. Most of the time it will set due to a open squib in the SRS circuit. A squib is simply the factory term for air...

Related articles

Top 10 Ways to Protect Your Car From Sun Damage
We We all know that sun exposure can harm our skin, but did you know the sun’s rays can also damage your car? When you leave your car in the sun for extended periods of time, the temperature inside can...
A Buyer’s Guide to the 2012 GMC Acadia
When When it comes to finding the right SUV for your family, it seems like there are always a lot of compromises to be made. One vehicle is so performance and off-road oriented that you can’t imagine taking your kids...
How to Modify the Alpine Navigation in an Acura or Honda
Modifying Modifying the original equipment manufacturer (OEM) navigation system of your Acura or Honda vehicle with aftermarket software is an easy way to add additional customization features to the already-installed system. Using a simple third-party computer program and a...