Q: How do I erase the memory of HomeLink?

asked by on

How do I erase the memory of HomeLink?

If you no longer use a garage door or need to add in a new door and the spaces are all full, you may have to erase the memory of HomeLink.

  1. Press the two outside buttons on HomeLink and hold for 10 seconds. The indicator light will flash.

Tip

When you sell your car, you’ll want to erase the memory of HomeLink.

Was this answer helpful?
The statements expressed above are only for informational purposes and should be independently verified. Please see our terms of service for more details
  1. Home
  2. Questions
  3. How do I erase the memory of HomeLink?

Get an instant quote for your car

Our certified mechanics come to you ・Backed by 12-month, 12,000-mile guarantee・Fair and transparent pricing

Get a quote

What others are asking

Q: 2012 chevy cruze 1.4 engine was making a ticking/rattling noise for around 3 days while idling and in reverse.

What you are describing sounds like the noise associated with a lack of proper oiling lubrication in the valve train. This may happen for a number of reasons, but could be due to a failing oil pump or plugged oil...

Q: Overheated now cranks but won't start

This could mean a few different problems. However, it is likely depending on how hot your car's engine got as a result of the overheating may have been a blown head gasket, which will cause the vehicle to not start....

Q: Q: Engine not turning over when starting.

The most common problem for the engine that will not crank (if the battery is okay) is the starter. I recommend that starter is checked for proper power getting to it from the battery and the ignition switch before replacing...

Related articles

How Long Does a Distributor O Ring Last?
The distributor is part of the ignition system in your vehicle and its purpose is to route high voltage from the ignition coil to the spark plug. The spark plug then...
P0052 OBD-II Trouble Code: HO2S Heater Control Circuit High (Bank 2 Sensor 1)
P0052 code definition HO2S Heater Control Circuit High (Bank 2 Sensor 1) What the...
P2103 OBD-II Trouble Code: Throttle Actuator Control Motor Circuit High
P2103 means there is a fault with the throttle actuator control motor circuit, likely due to a defective electrical component or part.