Q: How do I clean the engine in my truck?
How do I clean the engine in my truck?
The engine in your truck will perform better when it is free of grease and dirt. Grease and dirt build up over time and can be removed by a simple cleaning. To clean the engine.
Cover up the electrical areas to prevent damage.
Rinse the engine off.
Scrub certain spots if necessary.
The statements expressed above are only for informational purposes and should be independently verified. Please see our
terms of service
for more details
Get an instant quote for your car
Our certified mechanics come to you ・Backed by 12-month, 12,000-mile guarantee・Fair and transparent pricing
What others are asking
Lights not working after battery change.
The systems share two different fuses. The 30amp headlight fuse and the 15amp meter fuse. These two fuses may be blown and would need to be checked before further diagnostics would be done. If your bad battery was jump started...
Check Engine code P0340
The code P0430 on this car is one of the most common failures that occurs. This code indicates a problem with the crankshaft sensor. I recommend seeking a certified mechanic, such as one from YourMechanic, to come and test your...
Scraped a small layer off of my tire wall; should I be worried?
I would talk to the insurance company if you have full coverage with a low deductible so you can get the rim and tire replaced. If you decide to not go with the insurance route then you should at least...
Where is the canister purge selinoid located at?
The EVAP system is located in the rear of the vehicle near the fuel tank, which may be part of your problem in the event there is a leak in the EVAP system. Your car has a small purge valve...
Ck engine soon light is on
If your vehicle's check engine light (https://www.yourmechanic.com/article/what-does-the-check-engine-warning-light-mean-by-spencer-cates) illuminates, there is a malfunction that should be investigated and repaired. However, the seriousness of the malfunction is hard to judge unless and until a Code Scanner is used by the Mechanic to...
My car doesn't have a check Engine light on but when I took it the mechanic they found two codes
You will need to have the ignition system tested to look at the misfire data to find the exact cylinder coil that is causing the code. Misfire data in the computer memory will show the cylinder that is misfiring and...
I have a service autotraction system message come on in my Ford Fusion 2012 se 2.5L. I was wondering the cost
The cost to repair the system is highly dependent on exactly what is wrong and that can only be determined after a diagnostic is performed. If a wire has come loose, the cost to repair will be quite low. If...
Related articles
2012 Ford Mustang vs. 2012 Dodge Charger: Which One Should I Buy?
Technically these two vehicles have wildly different classifications: compact for the Ford Mustang and large car for the Dodge Charger. However, who would consider either one anything other than a muscle car? These cars are meant for speed, fun, and...
How to Clean Your Car Cover
A A car cover (https://www.yourmechanic.com/article/how-to-cover-your-car-by-mark-vallet) can be a very handy tool for keeping the exterior of your car protected and clean. By using a car cover, you are protecting your vehicle from leaves, sap, dust, bird droppings, and all sorts...
How to Use a Self-Service Car Wash
A self service car wash is cheaper than a drive through or automatic car wash. A hand car wash is also less damaging to your car paint and car wax.
Browse other content
Services
Maintenance