Q: Heat, oil pressure, battery gauge all not working. Indicator lights dont show when key is in in on position.

Hi, it sounds like you have a defective clutch master cylinder. I would inspect the clutch master cylinder as well as the slave cylinder. To replace the clutch master cylinder drain the brake fluid out the reservoir then disconnect the...

You would need to have the system scanned when there is a no start to see if you are getting a crankshaft (https://www.yourmechanic.com/article/symptoms-of-a-bad-or-failing-crankshaft-position-sensor) and camshaft sensor (https://www.yourmechanic.com/article/symptoms-of-a-bad-or-failing-camshaft-position-sensor) signals. The camshaft sensor may be hitting the camshaft when it is hot...

Hey there. It sounds like you may have a mass air sensor problem (https://www.yourmechanic.com/services/mass-airflow-sensor-replacement) or an intake leak between the throttle body (https://www.yourmechanic.com/services/throttle-body-replacement) and mass air sensor. This is a perfect example of why you should have a mechanic conduct...

The DTC P0740 (https://www.yourmechanic.com/article/p0421-obd-ii-trouble-code-torque-converter-clutch-circuit-malfunction-by-andrew-quinn) is for a "Problem in Lock-up Control System". This code means that there is most likely a problem within the transmission. It could also possibly be caused by a wiring issue or a control module. It...

If the car has sat parked for 2 years with fuel left in the fuel rail and gas tank, be sure the fuel tank is thoroughly emptied BEFORE you add fresh gas. The injectors are probably plugged with varnish and...

When the engine cranks but does not start, this is usually related to a fuel or ignition issue. Since this engine has a distributor, I would recommend checking the distributor, distributor cap, and rotor (https://www.yourmechanic.com/services/distributor-replacement) for any damages. Then I...

Hi there. The best advice I can offer is to have a professional mobile mechanic come to your location and complete a car is overheating inspection (https://www.yourmechanic.com/services/car-is-overheating-inspection). My fear however, is that the frequent overheating may have caused internal engine...

Check to see if any diagnostic trouble codes have been stored in both the PCM and TCM. Check the fuses in the circuits that power the transmission controls. Occasionally, a short in a sensor such as an oxygen sensor will...

Hi There, Generally, the check engine light (https://www.yourmechanic.com/services/check-engine-light-is-on-inspection) comes on when something fairly serious is going on with the vehicle. If the problem were related to an electrical voltage problem, the charging system light will usually come on. The check...