Q: Fuel Vapor Leak Detection Pump on a 2014 Chrysler 200 at ???

asked by on

Where is the location of the Fuel Vapor Leak Detection Pump on a 2014 Chrysler 200

My car has 69900 miles.
My car has an automatic transmission.

Hi there. The EVAP detection pump on most Chrysler’s are located under the driver-side rear wheel well. To access and properly remove it, I would highly suggest purchasing a service and repair manual for your vehicle.

Was this answer helpful?
The statements expressed above are only for informational purposes and should be independently verified. Please see our terms of service for more details
  1. Home
  2. Questions
  3. Fuel Vapor Leak Detection Pump on a 2014 Chrysler 200 at ???

Get an instant quote for your car

Our certified mechanics come to you ・Backed by 12-month, 12,000-mile guarantee・Fair and transparent pricing

Get a quote

What others are asking

Q: Should I replace both front struts at the same time?

Hi there. I recommend replacing both struts for the front at the same time, as they have springs that control the ride height and also have shocks that control the tire-to-road contact. Plus, you will not have to worry about...

Q: Can resetting 2014 Chevy captiva computer stop the reduced engine power

Hi there. Unfortunately, this is a very difficult question to answer since we don't know which codes are showing up during an OBD-II diagnostic exam. However, what the local auto parts store probably did was a code scan and not...

Q: Car feels like it's going to stall when stopped, just had timing belt and water pump replaced. Is the timing off?

It's not really likely that the timing is off. Modern cars with distributorless ignition rarely have any issues with the timing. If you're having problems with your idle the first thing to look for is air leaks. Any air that...

Related articles

P0052 OBD-II Trouble Code: HO2S Heater Control Circuit High (Bank 2 Sensor 1)
P0052 code definition HO2S Heater Control Circuit High (Bank 2 Sensor 1) What the...
P2428 OBD-II Trouble Code: Exhaust Gas Temperature Too High Bank 1
P2428 code definition A P2428 trouble code signifies that the PCM has detected a problem in the exhaust gas temperature sensor circuit in bank 1, which subsequently contains the number one...
P2103 OBD-II Trouble Code: Throttle Actuator Control Motor Circuit High
P2103 means there is a fault with the throttle actuator control motor circuit, likely due to a defective electrical component or part.