Is my hazard light suppose to light up in my Ford Focus a...
Responses
AhmedT111
260 days ago
Hello there and thank you for contacting JustAnswer,Is the light on even when you shut the car off?
AhmedT111
260 days ago
But the actual lights are off ?
Customer
260 days ago
No thanksThe hazard red light is illuminated but not flashing.although the hazard lights work when I press on it.Is this normal for it to illuminate?
AhmedT111
260 days ago
It’s probably just a glitch I don’t think it’s gonna drain your battery. Give it a couple of days it might go away.
Customer
260 days ago
Ok will do. Is it a safety issue at all?
AhmedT111
260 days ago
Not at all, as long as they don’t engage you’re fine.
Customer
260 days ago
What a relief! But what do you mean by engage? Thanks
AhmedT111
260 days ago
Your hazards don’t turn on.You’re welcome
Customer
260 days ago
Oh good. I feel better now and will keep an eye on it. Mahalo \*\*\*\*\* \*\*\*\*\*!
AhmedT111
260 days ago
Mahalo \*\*\*\*\* \*\*\*\*\*!!
Customer
260 days ago
Alright keep safe!
AhmedT111
260 days ago
Thank you. You too. Always reach out with any questions.
Customer
260 days ago
Will surely do. Thanks.
AhmedT111
260 days ago
Okay
Still not sure what you need?
Have a certified mobile mechanic diagnose what's wrong with your car, at your home or office.
Top Questions
Trending Topics
What others are asking
Serpentine belt not spinning
It is likely that one of your ribbed or slotted pulleys has seized up causing your belt to be unable to spin. It is also possible that there may be a problem with the crankshaft drive pulley. It is possible...
Buzzing noise wheels steering
Hello. This can be caused by a number of things. Most of the time it is due to a brake pad sensor rubbing on the rotor. Once it does this long enough, it will break and the noise will stop....
My car cranks but will cut off shorts after starting up. If i start it up again, it will crank but runs and tries to cut off. 2009 Mercedes Benz C300
Hello. Many different faults will cause your 2009 Mercedes C300 to cut off after starting. The most common would be a fuel pump (https://www.yourmechanic.com/services/fuel-pump-replacement), fuel filter (https://www.yourmechanic.com/services/fuel-filter-replacement), battery (https://www.yourmechanic.com/services/battery-replacement), alternator (https://www.yourmechanic.com/services/alternator-replacement), battery cable (https://www.yourmechanic.com/services/battery-cable-replacement), crank sensor (https://www.yourmechanic.com/services/crankshaft-position-sensor-replacement), or camshaft position...
Blinking check engine light.
Engine misfires can be caused by many different problems, but there are a few suspects that occur more than others. Generally, misfires are caused by either a spark or fuel issue or in cases, a combination of both. Spark related...
car starts fine sometimes after its turn off wont start for while
Hi there: Most of the time when your car won't start it's due to a fault with the ignition or fuel system. If the issue is inconsistent as you've described, it's possible that you have a loose electrical wire that...
I need help with the glove box removal.
Hi there. To remove the glove box there are two Torx screws just inside on the top of the glove box. On bottom under the base of glove box door (external) are two 8mm bolts. Once the screws and bolts...
Won't move sound like a cat in a blender
I don't know what a cat in a blender sounds like, but I think I may know what it is that you are hearing. It's possible that you have had a CV joint fail, in which case the transmission and...
Took my car in for a tune up and oil change. The next day the rpm's are running high, super loud, and running very hard. What can it be?
Check the throttle plate and position sensor on the engine. When the shop performed a tune-up they could have cleaned up the throttle plate and got the throttle position sensor wet. If the sensor is wet then the engine may...
2012 Chevy traverse rear cabin hvac fan continues to run when the vehicle is turned off. How can I fix this?
If there is a relay in the circuit, it is possible the relay contacts are stuck closed. The switch could be stuck, too. Inasmuch as micro- and PC-board mounted relays are used, really the thing to do is use the...
Browse other content
Services
Estimates
Is my hazard light suppose to light up in my Ford Focus at all times? Mechanic's Assistant: Just to clarify, what are the exact lights you're talking about? Hazard light in middle of dashboard triangular. Mechanic's A...
Is my hazard light suppose to light up in my Ford Focus at all times? Mechanic's Assistant: Just to clarify, what are the exact lights you're talking about? Hazard light in middle of dashboard triangular. Mechanic's Assistant: What year is your Focus? 2005 Mechanic's Assistant: Are you fixing your Focus yourself? What have you tried so far? No