Q: Do I have to remove the upper intake manifold to replace my fuel pressure regulator ?
do I have to remove the upper intake manifold to replace the fuel pressure regulator
My car has 226000 miles.
My car has an automatic transmission.
The statements expressed above are only for informational purposes and should be independently verified. Please see our
terms of service
for more details
Get an instant quote for your car
Our certified mechanics come to you ・Backed by 12-month, 12,000-mile guarantee・Fair and transparent pricing
What others are asking
Car washing/detailing schedule?
Hello, This is not really a mechanical question so I can not answer for how often is required to wash as this is a job YourMechanic would not perform. If you did not wash and wax the vehicle regularly the...
Warning code P0340
The camshaft sensor is a 3 wire sensor. Power and ground need to be checked and the signal wire can be scoped to see if a signal is present as the engine is running. Generally, the camshaft sensor itself is...
Can't find a ecu.
You can use the engine but you are going to have a hard time getting it to work since the two years are a generation apart when it comes to the computer systems. The 1994 was an OBD1 and the...
ABS T/C error light
Hey there, thanks for writing in about your 2006 Buick Terraza. There is a possibility of the connector C305 under the drivers seat on the rear getting corrosion and damage from water getting on the connector. The connector is not...
Dosen't always start
Hello. A no start condition, especially an intermittent one can be caused by a wide variety of issues. A few common causes for a no start condition are problems with the fuel or ignition systems, or perhaps an issue with...
Have codes p0068 and p2610 on 2011 Ford Fiesta, MAF sensor was replaced 7 months ago, intermittent stall when stopping but restart
I doubt these two codes are connected. The 2610 is a fault where the engine control module (ECM) cannot detect the power off cycle when the engine is turned off; meanwhile, the other code has to do with a throttle...
Air con not working and my car overheating but everything fill up
The air conditioning and engine cooling systems are diagnosed separately. The cause of no A/C can be determined through a non functioning A/C diagnostic (https://www.yourmechanic.com/services/ac-is-not-working-inspection). Engine overheating typically occurs if the engine cooling thermostat has failed, the water pump, or...
My car is off, stuck in drive but the shift handle in park.
Hi Ana. Thanks for submitting your question today. It's quite possible that the gear shift lever may have broken, if the indicator is telling you the car is in "DRIVE" gear but it is pushed forward. As a safety device,...
Related articles
A Buyer’s Guide to the 2012 Chevrolet Volt
Whether Whether you’re concerned about the environment or just want a vehicle that allows you to use less gas, the 2012 Chevrolet Volt might be just right for you. Designed to run entirely via an electric current, this electric hybrid...
The Best Used Cars to Buy If You’re an Athletic Coach
If If you are an athletic coach, you need a used vehicle with tons of room to transport gear. Once in awhile, you may have to take a player or two along with you as well. What this means is...
The Best Used Cars to Buy If You’re an Electrician
As As an electrician, you have to haul around wiring, tools and equipment, and tons of supplies. You can’t get by with a small used car, or even a big one. What you probably need is a good used cargo...
Browse other content
Cities
Services
Estimates