Q: Do ball joints that are sealed come pre greased since there's no way of greaseing them

asked by on September 27, 2017

Does ball joints that are sealed no grease fitting come pre greased since there are no way of greaseing them thanks

Sealed ball joints that do not have a grease fitting are lubed for life and are not serviceable and you cannot lube them. These type of joints are greased from the factory and sealed.

The statements expressed above are only for informational purposes and should be independently verified. Please see our terms of service for more details

Get an instant quote for your car

Our certified mechanics come to you ・Backed by 12-month, 12,000-mile guarantee・Fair and transparent pricing


Experienced Mechanic?

Earn up to $65/hr

What others are asking

At >60mph speed when I lift foot from accelerator, there is vibration in steering. clunk noise on bumps.

As always, the first order of business is to confirm the diagnosis. If the Mechanic showed you "looseness" in those parts, that's fine but "a" concern is whether or not they are giving you "assurance" that once those parts are...

Alignment

Hello. You only need to change the parts that are actually loose. If the ball joint is loose then it needs to be replaced. If the lower control arm has worn out or missing bushings then those should be replaced....

driver side lower ball joint rubbing rim.

Hi there. The control arm bushing can cause the lower ball joint to rest on the rim. If the bushings are missing, the lower control arm will move forward or backwards with the vehicle during turns. This can put a...

Lower ball joint

Hi there. When replacing the lower ball joints to your vehicle, you will need to press down on the ball joint to remove it. Before trying to remove the ball joint, check to see if there is a snap ring...

Noise when turning

Among the possibilities are the strut bearings, strut mounts, the strut itself, the outer cv axle joints, and/or any suspension component, such as a tie rod end, ball joint, sway bar mount, or suspension bushing that is loose or worn,...

What type of Ball Joint System does a 2005 Nissan Altima Have? Or where can I find this information ? 2005 Nissan Altima

Hello - the front suspension on your Altima utilizes a lower control arm (with a pressed in ball joint), and a strut/spring assembly. The ball joint comes pressed into the aluminum lower control arm, and is generally not available separately....

Metal-rubbing noise from back-left tire area

Hey there, thanks for writing in about your 2000 Saturn LS. The ball joint and the lower control arm work together in connection with the alignment of your car. When either of these two components are not working correctly or...

Is it hard to change ball joints?

Hi there - replacing ball joints usually requires specialized tools for pressing the old ball joints out, the new joints in, and tools for compressing and holding the vehicle spring, while the ball joint is replaced. From that standpoint, yes,...

What Suspension Components Are Most Likely To Fail

The suspension on your vehicle was designed to give you the best combination of comfort, reliability, and performance. Depending on the manufacturer, the suspension can be fairly simple or it can be very complex. Your suspension can consist of a...

Related articles

Symptoms of a Bad or Failing Ball Joint (Front)
Common signs include clunking noises and excessive vibration from the front, and you may start steering to the right or left unintentionally.
Symptoms of a Bad or Failing Ball Joint (Rear)
Common signs include clunking noises and tire wear in the rear. You might also start steering to the right or left unintentionally.
How Often Should the Steering System Be Inspected?
It’s It’s usually better to fix an automotive problem early than to wait until it causes more damage or even an accident. And that general principle applies to the steering system. Luckily, periodic inspection and maintenance of the steering system...