Q: Cost to change old fuse 2008 Mazda 3

asked by on

Cost to change old fuse and where is it located?

My car has 95000 miles.
My car has an automatic transmission.

Fuse replacement averages $72 to $91 but you can get an exact quote if you click on "Get a Quote" at YourMechanic’s fuse replacement service page. Fuses are located in a variety of spots in the car including in an underhood fuse box as well as in the passenger compartment. Every circuit has its own fuse and, in addition, there are fusible links in most cars as well. Please note that fuses are not a consumable or maintenance item. Therefore, in many if not most instances when a fuse blows there is an underlying fault in the circuit that the fuse protects. Consequently, a new fuse may blow immediately and that just simply means the circuit will have to be diagnosed and the fault found and repaired before a new fuse is installed. Obviously, the mechanic who replaces the fuse will assist in the event that the circuit has a fault. If you request fuse replacement service, the responding certified mechanic will get this taken care of for you. If you have further questions or concerns, do not hesitate to re-contact YourMechanic as we are always here to help you.

Was this answer helpful?
The statements expressed above are only for informational purposes and should be independently verified. Please see our terms of service for more details
  1. Home
  2. Questions
  3. Cost to change old fuse 2008 Mazda 3

Get an instant quote for your car

Our certified mechanics come to you ・Backed by 12-month, 12,000-mile guarantee・Fair and transparent pricing

Get a quote

What others are asking

Q: P0126 - check engine code

It is quite possible the code was set as an intermittent problem. The thermostat may have been stuck at one point, freed up and began working again, and then allowed the light to go off. Most computer controlled engine systems...

Q: Stop fuse keeps blowing

Hello there, when a fuse blows in your 2004 Chevrolet Aveo, it indicates there is an issue with the wiring. Fuses typically blow when there is a short to power or to much power drawn. If you have replaced the...

Q: TJ did an inspection on a 2008 Land Rover LR2 @Cars of Tampa Inc. How soon would some of the 'good' things need 2b worked on?

Hi Cassandra: I will try to help you. For safety reasons, the steering gear leak should be repaired first. After that the priority would be the replacement of the axles and then repair of the crankshaft seal leak. Technically, you...

Related articles

How Long Does a Distributor O Ring Last?
The distributor is part of the ignition system in your vehicle and its purpose is to route high voltage from the ignition coil to the spark plug. The spark plug then...
How Long Does a Heater Control Valve Last?
Keeping the right amount of coolant in a car is essential in keeping the engine at the right temperature. Failing to have the right amount of coolant or even bad elements...
P0052 OBD-II Trouble Code: HO2S Heater Control Circuit High (Bank 2 Sensor 1)
P0052 code definition HO2S Heater Control Circuit High (Bank 2 Sensor 1) What the...