Q: Cabon build up, mass oil consumpsion, rings need to be changed

Hi there. To remove the fuel rail, simply remove the bolts that secure the rail onto the intake manifold and all of the brackets off the rail. Take a pry bar and gently pry up on the fuel rail to...

The check engine light comes on when the computer systems on the vehicle detects a problem. There are hundreds of possible codes and problems that can cause those codes. You will need to have the computer tested to see what...

Cable adjustment was the correct thing to try, but it won't help much if the ball and socket in the shifter is bad. The VW shifters use a nylon ball and socket joint that can crack, throwing everything off. Try...

Hi there. P0405 is an OBD-II generic code (https://www.yourmechanic.com/article/p0405-obd-ii-trouble-code-exhaust-gas-recirculation-sensor-circuit-a-low-by-jay-safford) that the engine control module (ECM) detected the engine exhaust gas recirculation (EGR) sensor has went below its specification range. A short to ground of the sensor input to the ECM....

Check the drive belt to the vehicle and see if its cracked or glazed. A cracked or glazed drive belt will squeal when under a load. Also, check the pulleys and see if the bearings are going out. A drive...

Hello, It sounds like you may have a faulty oil pressure sensor. The oil pressure light will usually come on when a few things could be happening. Either the motor is in fact low on oil, the oil pump could...

If you have 4 wheel drive, the noise might be due to a failed outboard CV joint. Another possibility is brake interference or wheel bearing noise although if you had a defective wheel bearing you would normally hear the noise...

The engine should always operate in the "normal" range as shown on your temperature gauge. If the temperature is too high, shut down the engine as overheating can have disastrous consequences (costly repairs). If too low, that is not an...