Popular questions

Question
I have a 2006 Suzuki Forenza and recently just got the engine replaced. after driving it for a while yesterday the malfunction ind
Without knowing what caused the check engine light to come on or the codes stored it would not be able to be determined if engine damage can occur if you continue to drive it. I would recommend having the codes...
Question
My seat won’t recline forward 2007 Nissan altima
If you have a non-powered seat, the cause could be mechanical in nature and involve levers and/or the seat track. If you have a powered seat, depending on exactly what you mean by "recline" the problem could be electrical and/or...
Question
Fuel leaking out of car
The fuel lines and filter would have to be checked to see what is causing your leak. I recommend you do not attempt to drive the vehicle till having it looked at and fixed. The leak may pose a fire...
Question
Noticed rubbing noise from transmission after replacing bearings and lug studs.
Hello. This is tough to diagnose without hearing the sound specifically, as the transmission should not be rubbing on any other components in the vehicle. I would recommend checking the driveline components to be sure there are no loose or...
Question
Hard acceleration and hard braking when stop
You may be having a normal condition. When you accelerate hard, you are dumping a large amount of fuel into the engine and then stopping quick and shutting the throttle. You still have all that fuel in the engine and...
Question
Power steering problems after changing the line to the pump.
The control valve in the power steering system maybe stuck causing the system to not push the fluid to the rack and pinion. Check the fluid to the power steering pump and see if the fluid has bubbles in it....
Question
My Chevr HHR (2006) has milky oil, and white smoke puffs out of the dipstick tube. The car doesn't overheat,and the heater works.
Check for any change in coolant level in the overflow reservoir. If no change over, say, 500 miles, you simply have a high level of condensation because there is absolutely no other source of water to the engine. You can...
Question
the idle is a little rocky, but better since i put iridium plugs in it but it still didn't accelerate as soon as i press the gas
The backfiring and the rough idle are probably related. Backfiring is often caused by a too lean or too rich air-to-fuel ratio although a few other causes are discussed below. A backfire in the intake manifold is caused by a...
Question
Knock sensor 2009 Pontiac G3
Hi there - the knock sensor on this engine is under the intake manifold, just behind the power steering pump, and is best seen and accessed from underneath the car. For assistance with a replacement, have a knock sensor replacement...
Question
how do i fix it
Any number of components can cause a stalling issue. It can be as simple as a vacuum leak, to as severe as an engine control unit or more. If there is a vacuum leak caused by a broken intake hose,...
Question
lights on for power steering and stabilitrack on
Hello. Thank you for writing in. The electronic power steering system can absolutely be replaced. Due to the fact the light is on the system is obviously detecting an issue, and a diagnostic scan of the vehicle can be done...
Question
Car locks not working, keyless entry not working
When this occurs, there are a few usual culprits. The most common include: the key fob failing, the car's security system is malfunctioning, or the door lock actuators have failed. The other door lock actuators failing is the most unlikely...
Question
Can i punch out my cats?
Claimed by Jay Safford
Question
Gas pump continuously shuts off when filling up tank.
The vent hose on the fuel tank to the fuel filler neck is plugged up and is not allowing the air (fumes) to cycle through the system as the fuel is being poured. To verify this, the next time you...
Question
Engine won't start
A number of things can cause a crank / no start condition. First, you must check for the basics. Is the engine getting fuel? If not, the problem could be a bad fuel pump and/or bad fuel pressure regulator. ...
Question
Nothing happens when I push the gas pedal
The P0104 is probably the key. This is a code for the Mass Air Flow circuit. What it means is that the reading from the MAF is not along the lines of what the ECU expects. The 171 and 174...
Question
Clunking noise in the front
Loose and/or worn strut mounts are a common cause of this noise. If you jounce the suspension and have an assistant listen near the top of each spring tower you can sometimes hear the clunk noise, albeit the noise will...
Question
Ford F150 shakes when pressing gas
If you are getting a check engine light coming on and flashing of the light when problem is happening. I would recommend having the engine computer scanned to see if you have misfire codes or codes to the intake manifold...
Question
engine light comes on after oil change service
Hi there: On modern vehicles, there are two different types of "warning lights"; routine service lights and trouble code warning lights. In most cases, when you have a routine service light that illuminates, it's set to do so at certain...
Question
How do I use my power windows?
There are many control switches to adjust the powered windows on your vehicle. On the driver’s side door, you’ll find switches to control all windows on your vehicle. If you need to adjust windows while in a passenger’s seat, you’ll...
Question
Why my car remote control is not working
The first thing to do is to replace the battery since you did not mention you replaced the battery. Once battery is replaced and making sure battery connections are clean and tight then check operation of the remote. Then if...
Question
Where is the water pump control relay located on 06 bmw 325i
The water pump control module is mounted in the left rear of the engine compartment. The system does not have a relay but a control module.