Skip the auto shop - Our mechanics make house calls

Q: how do i fix it

asked by on

Car keeps stalln out and i got good fuel pump and relay

My car has 120000 miles.
My car has an automatic transmission.

Any number of components can cause a stalling issue. It can be as simple as a vacuum leak, to as severe as an engine control unit or more. If there is a vacuum leak caused by a broken intake hose, vacuum line, or intake manifold gasket for examples, the air/fuel mixture will be too lean from the additional air, and the engine could be low on power and even stall. Also, any of the numerous sensors or switches that the ecu read information from the engine, coolant temperature, crankshaft position, mass air flow,etc. can all lead to stalling issues if any of them are bad, shorted, or not reading properly. Have a certified technician inspect the vehicle to find the exact cause of the stalling.

Was this answer helpful?

Need advice from certified mechanic? Get help now!

Over 1000 mechanics are ready to answer your question.
The statements expressed above are only for informational purposes and should be independently verified. Please see our terms of service for more details

Ask a Mechanic
(100% Free)

Have a car question? Get free advice from our top-rated mechanics.

Ask A Mechanic
Over 10,000 questions answered!

Get an instant quote for your car

Our certified mechanics come to you ・Backed by 12-month, 12,000-mile guarantee・Fair and transparent pricing

Get a quote

What others are asking

Q: Why does my car loose RPM when I'm driving?

Hi there. First check all of the fluids and make sure that they are full and top off all low fluids. Then check the battery and make sure that it has a full charge of 12.6 volts. If the voltage...

Q: why is my car shaking & raddle & why is my check engine light still on after i added oil

Hello, and thank you for writing in. Typically shaking is a sign of misfiring. Misfiring occurs when the air, fuel, or spark are being sent to the engine improperly. Since the check engine light is on, there is a strong...

Q: Windshield wipers don't work after a previous repair

Check for power and ground to the wiper motor when they are switched on. If no power is there, go to the combination switch and check for the same. Combination switch (signal stalk) is a common failure point. There can...

Related articles

P0052 OBD-II Trouble Code: HO2S Heater Control Circuit High (Bank 2 Sensor 1)
P0052 code definition HO2S Heater Control Circuit High (Bank 2 Sensor 1) What the...
What are the Car Pool Rules in Hawaii?
Hawaii is widely regarded as a land of vacation and relaxation, and as such, its scenic roads and routes are far better known than the state’s freeways. But, as with all...
P2103 OBD-II Trouble Code: Throttle Actuator Control Motor Circuit High
P2103 means there is a fault with the throttle actuator control motor circuit, likely due to a defective electrical component or part.