Popular questions

If the clutch is not engaging a major component has failed such as the pressure plate, diaphragm spring or possibly input shaft components which have splines on them. Although a mechanic will perform some initial checks to rule out simpler...

Hi there. I would need to know if, when it will not start, the engine cranks over or you get nothing. If it will not even crank over, then most of the time this is caused by a failing starter....

Hi there: The symptoms you're describing above could be one of several different problems; ranging from serious internal engine damage caused by the lack of engine oil for an extended period to simple items such as a malfunctioning crankshaft position...

Locking the trunk of your Honda Accord is easy. You just need to: Insert the key into the lock on the trunk release latch located on the driver side floorboard. Turn it to the left to lock the...

Hi there. The issue is the coolant thermostat temperature sensor. The sensor is malfunctioning causing the computer (ECM) to think that the engine is either too cold or too hot and causing the fuel mixture to be off. I recommend...

Hey there. It sounds like the noise comes around when you are using the clutch which sounds to me like you may have an issue with your throwout bearing. The part on the vehicle may have been faulty and failed...

When it comes to metal shavings in the engine, you have to understand that those shavings will go everywhere. They will get between moving parts and cause further damage. They can get into the rings on the pistons and score...

The most likely cause of this issue would be a wheel/vehicle speed sensor or an ABS control module. The wheel speed sensors are what sends the data of what the wheels are doing, and the ABS module receives and...

The noise is the coolant is turning into steam due to low amount of coolant to water concentrations. The ratio should be 50% coolant to 50% distilled water or just purchase a 50/50 coolant that is already mixed. Since you...

Opening the hood is the vital first step in being able to keep track of maintenance items like oil level, coolant level, power steering fluid level, air filter condition and more. Thankfully, it’s easy to do on the Altima. Here’s...

Unless the fluid is obviously contaminated, and thus there is a possibility of a blocked transmission filter, I wouldn't start the diagnostic with a fluid/filter change. Eventually, you should change the fluid and the filter but more likely causes of...

If the idle air control valve or mass air sensor is having problems. If the idle valve is sticking closed it can cause the engine to idle very low and rough, and will run fine if the throttle is held...

You most likely have a bad ignition spark control module.

Hello - if your car passed emissions testing, and the Check Engine light is NOT on, your vehicle is at least passing the on-board diagnostics. Many other factors can affect fuel mileage however, tire pressure, clogged fuel filter, short trips...

Hello there. Costs will vary depending on whether you have the 4 cylinder or 6 cylinder. The 6 cylinder requires 3 hours to complete the two tasks (alternator plus belt). The 4 cylinder requires a little over 2 hours. These...

It sounds to me like there may be an issue with the blower fan behind the dash cover. This is the fan that creates the airflow inside the vehicle. Many times the dealer will only fix the problem if it...

Hello, thanks for your question. You could watch the clutch fluid as it mentions in the test, but this really doesn't tell you much. Most of the time this is caused by a bad clutch master cylinder. If the fluid...

A vibration while driving is generally caused by something that rotates with vehicle speed. A number of components can be the cause. An out of balance tire or tires, as well as an out of round tire (shifted belt) or...

Your vehicle has a recall on the headlight wiring connectors and bulbs. If the connectors do not have a made in Mexico tag on them, then they will need to be replaced with new bulbs and connectors as per recall...

The stalling may well be caused by a failure of the crankshaft position sensor. This device provides timing instructions for the ignition system. When it fails, the engine no longer gets spark at the spark plugs and stalls. When the...

Hi there. Check to see if the battery cables are tight. If the cables are tight, then check the brake switch on the brake pedal. It may not be responding to the computer as it could be damaged or shorted....

Hello, thanks for writing in. It is possible that you have a fuel injection issue, but that is not that common on this vehicle. Most of the time when this occurs with a ticking noise also it is due to...

Hi Robert. Thanks for contacting us tonight. The wrench light is a warning or service light, that indicates that the vehicle is due to for a routine service check. With 150,000 miles, this is rather common and often indicates a...

The short answer is – yes, every state requires emission testing. However, there can be a lot of variation from state to state and even within a state. All states require annual or biennial tests, but in many states, testing...