Popular questions

Hello. I would think that your strut has blown out an internal seal or a brake component such as a brake line has failed. I suggest to have a professional technician inspect the braking system and strut for leakage to...

Hello. If the problem is only happening when in gear, after a load is put on the engine, then you may have a fuel pressure problem. Have the fuel pressure tested to see if there is correct pressures and a...

This may be stating the obvious but, it never hurts to go over the basics such as wheel balance and suspension play. Make sure that your vehicle's suspension parts do not have any excess movement as this can cause vibration...

A P0758 code indicates a problem with the vehicle's shift solenoid, specifically shift solenoid B. If this light has come on, then the vehicle may be experiencing poor performance, or unusual shifting. As this component is located on the underside...

Hi there. On modern automobiles, fuel odors should not be detectable at anytime beyond refueling. A strong smell of gasoline can indicate a leaking fuel supply component (fuel filler hose, filter, or lines) or an evaporative emissions component (purge valve,...

The manufacturer shocks in the rear and the struts in the front do not seem to last very long before getting noisy or causing poor ride conditions. This seems to be a very common issue with other owners also. Many...

The vibration and jumping may be caused by a broken engine mount. Very often a failed engine mount will cause excessive movement and bump against the stops. An easy way to see this is to have the parking brake held...

Hi, it sounds like a bad hub is making the squeak noise you hear. To repair this, jack the vehicle on jack stands. Spin the wheel while lifted in the air and see if you hear the noise. If so you...

If you are noticing that the clutch is getting too easy to push, this could indicate that your clutch pressure plate is growing weak from broken or overheated springs in the clutch. It could be something else if you have...

Each door has an individual Lock knob directly above the door handle. Push this knob towards the front of the vehicle to lock that door, or push it towards the back of the vehicle to unlock that door.

Hello, thank you for writing in. Typically the fuel nozzle on the gas station's pump has a small hole in it. Once the fuel has filled up the tank and the filler neck, it reaches this small hole in the...

While the information provided on the Honda Prelude is a bit limited, my experience with this car leads me to believe that the tilt function on the sunroof has stopped operating correctly. If the sunroof can open and close...

Hi Omar. If the water pump was damaged, it's not always the only source of an overheating problem. There are generally two reasons why people will continually have an overheating issue after replacing a damaged part. First, it's quite common...

Ensuring that your doors are closed and locked is essential for safety while on the road. Thankfully, it’s a simple matter with the Honda Accord. Once everyone is seated in the vehicle, follow these simple steps: Check the Indicator...

Hello. If the coolant continues to go low, then there is a problem with the vehicle. It can be an external leak or the engine may have an internal failure which is causing the coolant to burn off. Since you...

You need to have the cooling system checked to see if there is combustion gases getting in the cooling system, causing it to get hotter than it should. Since you have overheating problems you may have a blown head gasket...

You should first confirm that the temperature controlled radiator cooling fans are functioning. If they are not working, or not working well, that would cause overheating at idle. The only way to condemn a radiator, other than if it is...

If the cruise control has been canceled, it can easily be resumed. When you resume the cruise control, the vehicle will automatically accelerate to the set speed. To resume, simply pull up on the cruise control lever. Tip This feature...

The rattle is most likely a strut or sway bar problem, the stalling may be caused by the idle air control valve sticking, and the brakes stopping low calls for a complete inspection due to safety reasons. I recommend having...

If necessary, the head restraints can be easily removed. To do so, simply lift up on a restraint to adjust it to the highest position. Then, press and hold the button at the base of the restraint, and pull up...

Greetings! I did not get your vehicle's engine size, but this concern plagues many vehicles. It seems the mechanical connection between the window glass and window regulator may have failed. In many cases, the mechanical connection can be repaired. More...

This is just a guess, but the problem could be with the gear selector or the transmission position switch. The starter relay will not close and the vehicle will not crank, unless the switch is in the neutral or park...

The most common failure is the window motor and regulator. I recommend having it checked to see what failed and a window motor and regulator replaced as an assembly is the most common repair. I recommend you have a mechanic...

There are several parts that when they fail, will cause the engine to stall and not restart. The crankshaft position sensor, ignition control, module, and the fuel pump. The first two will set trouble codes in the computer to aid...

I believe there was a recall done on the turn signals for your vehicle. You may check with your local dealership and see if this applies to your vehicle. If not, these are cars are known for having faulty turn...