Popular questions

Question
Vehicle will start but turns off when put into gears
Hello, thank you for writing in. When the transmission is put into gear, the engine is demanded to work under slightly different conditions. It is these changes that are likely triggering the engine to stall. The Torque converter lock up...
Question
Steering wheel vibrates when braking
Hello there. Many different issues could cause your vehicle to vibrate when braking. You have done well in replacing the most common causes for a vibration such as this. Other common culprits are the wheel bearings, the wheel itself, the...
Question
sluggish, stalling, check engine light came on
With the car not being able to upshift and the sluggishness issue that you have, there are a few potential causes. The most common would be a shift solenoid, torque converter, MAF sensor or a fuel pressure issue. You will...
Question
What type of rotors
Hello! They added metallic brakes on the front to give the front more stopping power than the rear, which is great for stopping during sudden braking. It will be beneficial to put slotted rotors and performance pads on the van,...
Question
can I use the positive and negative posts under the hood to maintain power to the computer while replacing main battery
If the two posts are indeed specified for jump starting, then the answer is "yes" you can safely install a 12 volt car battery there at the remote posts while you remove and replace the permanent car battery. Electrically, all...
Question
My gas cap replaced still no click
Having your gas cap not work correctly can be a frustrating experience. It appears that the concern with your Ford Escape may have something to do with the fuel filler neck not allowing the new factory gas cap to be...
Question
transmission not changing gears
The internal transmission shifting mechanism of the valve body to the forward clutches is not working, or the forward sprag clutches are broken. Only a transmission pressure test would be able confirm if the problem is in the valve body...
Question
I just replaced my idle control valve with a new one and the idle continues to go up and down. Why?
It sounds like you may have either installed a faulty idle control valve or you may potentially have a bad connector or wiring running to the idle control valve. You can test the functionality of the valve by checking its...
Question
Something is grinding when I stop
It is possible that your dust shield behind the rotor is coming in contact with the rotor sometimes. I would recommend to use a small screwdriver and try to pry the dust shield away from the rotor anywhere that it...
Question
Does using heat burn extra fuel?
Hey there. The heater in the car only requires the use of the heater blower to blow hot air out of the heater case. The heat is generated by blowing hot air across the heater core inside the A/C blower...
Question
I have a rubbing noise when i turn the wheel when sitting still but not at speed and i also have a lot of clunk noise over bumps.
Hi William. Thanks for contacting us today. Based on what you've indicated, it's quite possible that there could be multiple front end issues going on with your Saturn. The fact your CV boots are torn could indicate a failure of...
Question
Shocks
As long as the shock fits without hitting any components you should have no problems.
Question
We are not getting any spark from the coil pack and it still wont crank what could be the problem?
Hi there. Unfortunately, we are not quite clear as to what your engine is NOT doing. If the engine will not crank over, this is a starter issue and has nothing to do with ignition timing or spark. If the...
Question
weird engine noise
Hello. Though this can be caused by a transmission failure, most of the time it is either caused by a cracked flywheel or a failing timing chain. I usually try to narrow down the location of the noise as that...