Popular questions

Question
Where are the LATCH lower anchors?
Your rear seats have four lower anchors that can be used with any LATCH (Lower Anchors and Tethers for Children) child restraint system. The lower anchors are located on each side of the rear outboard seats, where the seat cushion...
Question
Advice on buying a Rav4
Out of those options, I'd say buy the '04 RAV4. The earlier ones had some problems with the oxygen sensors and catalytic converters. The '04's really didn't. I'd say get yourself an '04. They are really well made. If you...
Question
A/c controls go in and out and now when i turn the car off and take the keys out, the lights are still on. Honda accord 2000.
Hi there: Most of the time, this issue is caused by an electrical relay that has been damaged. It's possible that during your radio swap, this may have caused an electrical issue with your AC system. However, it's also possible...
Question
Car isn't shifting when pedal is all the way down and is slow.
Your engine management system is going into "limp mode" when the Check Engine light is illuminated, reducing engine power, and quite likely, leaving your automatic transmission in 2nd gear. This is why you are experiencing greatly diminished performance. Turning your...
Question
Speedometer and Odometer not working 2002 Mitsubishi Magna
Hello - the lack of speedometer and odometer function is most likely caused by a failure of the vehicle speed sensor (or the wiring to it). This sensor, and its wiring, would have to be tested with a voltmeter or...
Question
I have a Chrys 300, when I turn it on and put it into drive I hear a grinding noise. I think it's the drive shaft or differential.
Billing question sent to CS for the cost to repair the driveshaft or differential from making a grinding noise.
Question
How do I change songs on a CD with the steering wheel controls?
The steering wheel has switches on the back of it so that you can control the sound system without taking your hands off the wheel. To control a CD that you are listening to, you want to use the switches...
Question
Misfire on cylinder 8
Misfires are caused by lack of fuel or the ignition system isn't providing the needed spark. At least these are the most common single cylinder failures. It is possible, all be it remotely, that you have a compression problem, but...
Question
My mechanic said I needed an alternator. He fixed the starter now My car is making this loud knocking noise, what could it be?
Hi there. I believe we answered your question earlier, but if the mechanic is telling you that you need an alternator, it's possible the noise and the power issue is related. The alternator, like many other accessory systems is powered...
Question
Battery went flat causing alarm to sound and won't stop after changing battery
The most common methods to deal with this situation are to put the key in each door and lock and unlock to reset the alarm. You may need to do this in the trunk or hatch lid as well. The...
Question
Slow speed increase, check engine light on
Hello. If this occurred right after getting gas then you may have gotten contaminated fuel. If it has some water or some diesel in it then this will occur. Some of the time a fuel pump can fail after getting...
Question
Car cranks but doesnt start....
Hello. I would recommend checking a Chilton book to determine where the timing marks for the crank pulley are located. Chilton books provide an abundance of information that will help in diagnosing and repairing your vehicle. As for the fuel...
Question
Just did a tune up on my 84 olds cutlass supreme. 3.8. Afterward got a static sounds from stereo, then it died on the freeway
When you operated the car right after the tune-up, the coil somehow "found" a good enough path to ground for the ignition to function, but it was probably a high resistance path. That would have increased the load on the...
Question
ABS light constantly on ,on Dashbody
Hello Golden. Thanks for writing to YourMechanic.com for some advice on the ABS light issue. Driving with the ABS Light on is not a good idea because it means your ABS is not working properly. This means your vehicle may...
Question
The Esl is locked car won't start
With ignition on look to see if theft light is on or blinking to see if theft system is active. Sometimes another key if you have one will start vehicle if the key FOB is defective.If the battery is dead...
Question
Gas usage high
Depending on the conditions, 25 miles per gallon is not too bad, especially in the winter. Gas companies are required by the government to change the mixture of gas in the winter to decrease vehicle emissions. When they make a...
Question
Car shaking during acceleration and shifting between gears
This condition sounds like one BMW has noted on a technical service bulletin (TSB) concerning a software issue in the engine control module. There has been an updated software version developed by BMW but you will need to have this...
Question
Can you give me a thourough step by step on how to replace the drivers side cv axle on my 2015 dodge dart sxt
Hi...unfortunately, this is not a procedure that can be summarized in a brief space. Even prior to contemplating the job, you will need a calibrated torque wrench and the tightening specification for all removed bolts, particularly the axle hub nut...
Question
Loud bang and shaking starting car
Hello. It sounds like there is a broken engine mount or transmission mount that may be causing the banging noise that you are hearing. It is possible that something was damaged in the suspension system which could also cause a...
Question
My power sliding door on my 1996 Pontiac Transport moves really slow makes a whining noise and does not latch all the way shut.
Hi there. The sliding door has a track that the door rides in and allows the rollers on the door to move as the door motors operate. The track tends to get rust and buildup in it making the rollers...
Question
Bad Ignition switch Symptoms
If upon actuating the ignition switch you hear "crackling" noise in the dash, that could be due to arcing or a faulty component such as a relay that happens to be in the circuit that you are powering with the...