Popular questions

From the information provided on your Jeep Liberty, it leads me to believe that the problem may actually lie with the transmission and not with the fuel filter. After shifting into gear, if there is a delay in the engagement...

Hi there. If the engine is cranking over fine and it just will not start then I would start by cleaning out the throttle body. It is common for the throttle body to become dirty over time which can cause...

You will need to have the engine ignition spark checked to see if there is spark when it stalls and will not start. The most common cause is oil leaking into the distributor and shorting out the igniter and coil...

Hello, the pitman arm is attached to the steering gear but is not part of the steering gear assembly. This part would not be covered unless it was replaced when the steering gear was replaced. You could look at the...

While listening to your iPod through the sound system, you can fast forward and rewind through songs. To fast forward through a track, press and hold the Seek button for more than 0.8 seconds. To rewind through a track, press...

Hey there. The A/C pulley bearing may be binding causing the chirping. Try spraying each belt one at a time with some water in a spray bottle. The noise will change or go away when the belt that is chirping...

Hello. I would recommend checking a Chilton book to determine where the timing marks for the crank pulley are located. Chilton books provide an abundance of information that will help in diagnosing and repairing your vehicle. As for the fuel...

The boots may of not been installed correctly and/or the axle shaft was not installed all the way into the joint after removal leading to the clip not engaging the joint and binding the differential in the transmission. This is...

Hello, thank you for writing in. The vehicle may be having spark issues. If the spark is not strong enough to ignite all of the fuel, or does not ignite the fuel at all, the spark plugs may not be...

The cost of maintenance and repair is going to be slightly higher than an equivalent Japanese or domestic car, but the drive quality will be better as well. If you're buying a brand new car, you will get a full...

Hello. It is likely that the air conditioner compressor is breaking your serpentine belt because it has seized up. I suggest that you have a trained technician replace your serpentine belt to get your car back on the road safely....

The power steering in your car is electric. There is computer and an electric motor bolted to the steering column. If there is any malfunction, the computer will need to be scanned for codes to begin the diagnostics. There is...

Actually yes it is normal. I will go through a few things that you may or may not have done and hopefully we can get your issue resolved. When you put your crankshaft pulley on did you use an impact?...

Whether your Accord has a manual A/C, auto A/C or a built-in navigation system, activating the rear defogger is done in the same way. Find the button on the dash that says “Rear” and has a picture of...

I recommend having a mechanic come and look at the vehicle to check for vacuum leaks or coil problems. You may need to replace the coil pack and ignition module. These older engines may not register misfires as well as...

Hello. From what you describe it would appear that the aftermarket alarm system may be having an issue. If the alarm has done this since it was installed then it may be possible that it is wired improperly, or that...

Hey there. You need to try and reset the point gap to .025 and then run the engine again. You should also get a spark tester and see how much power your coil is putting out. If it is not...

As you already know, I would suggest testing the coil packs for spark. Try also checking the crank position sensor to be sure it is working properly. When these go bad they can often cause the coils to not produce...

Your rear seats have four lower anchors that can be used with any LATCH (Lower Anchors and Tethers for Children) child restraint system. The lower anchors are located on each side of the rear outboard seats, where the seat cushion...

P2502 and P2500 relate to vehicle electrical system faults, particularly the battery/charging system, although both codes can also implicate a faulty PCM (rare, though, absolute last thing to consider). The third code relates to an emission system sensor and you...

You will need to check the caliper slides are not binding and are lubed properly. If okay then with wheel off see if rotor is binding and then open the bleeder on the caliper to see if it releases the...

Hello, and thank you for writing in. There are several reasons why your vehicle may pull to one side or the other while braking. The first thing to consider is a warped rotor or faulty brake pads. When you replace...

Automotive mirrors are one of the most crucial aids used in safe driving. When properly adjusted, they allow the driver to quickly see objects and other vehicles that are around you without turning your head or losing focus on your...

Hi there: Without being there to inspect the installation work or complete a diagnostic scan to see if you have any error codes, it's nearly impossible for us to help you with this issue. Like any major repair, you might...