Popular questions

The OBD-II error code P-0016 is a generic code that indicates that the camshaft position sensor for bank one does not correlate to the signal from the crankshaft position sensor. Some of the common trigger points that create this code...

Hey, again Brandon. Yes, the output shaft speed sensor is located on the driver side, on the outside of the front differential.

If your key will not turn in the ignition, then it may be time for a new ignition lock cylinder. As this often requires disassembly of the steering column and even the need for a new key, I would recommend...

The parts required will depend on exactly what has failed and that, of course, is determined through both a diagnosis and an inspection upon disassembly if it turns out that the transmission has to be rebuilt. Your car has enough...

If the car has sat parked for 2 years with fuel left in the fuel rail and gas tank, be sure the fuel tank is thoroughly emptied BEFORE you add fresh gas. The injectors are probably plugged with varnish and...

Hello there, thanks for your question. I believe you are correct in the fact that the starter is most likely your issue. If all the lights, windows, radio, and wipers all function properly as they should, most likely the battery...

Hello. P0101 is the trouble code for an issue with the MAF sensor circuit range. This code is set when the computer detects an issue with the vehicle's MAF sensor signal. If the MAF sensor has been replaced, then it...

Hello, thank you for writing in. The first thing we need to determine is if this is a stock alarm or an aftermarket that was installed later. There may be a technical issue with the alarm module itself. The keys...

I would suggest checking the MAF sensor for starters, but also check timing to be sure it set properly. This can affect the fuel economy and the acceleration for sure. When the timing is not correct, the combustion cycle will...

Unless there is an engine management fault (total loss of power), your issue has to do with the transmission. Check to be sure there is adequate transmission fluid as a low level can cause malfunctions. The possible causes of failure...

This is a common sign of a failing CV joint. A CV (Constant Velocity) joint is a shaft that connects the transmission to the wheels, essentially transferring the power from the drive train directly to the wheels. The CV joint...

Hello, the concern you have I strongly advise not to drive. The issue needs to be addressed, the vehicle will become inoperable. The automatic transmission has 3 systems; electronic, hydraulic, and mechanical. What describe could be an internal mechanical...

Hello. There is a huge variance in manufacturer estimates of serpentine belt lifetime. This is understandable because operating conditions vary, vehicle designs vary and the belt material will degrade at different rates. You should get at least 50,000 miles out...

Hello there, thank you for asking about your 1992 Mazda MX-3. This may be caused by a variety of problems such as a vacuum leak or potentially a faulty idle air control valve. The high idle suggests that there may...

This shaking feeling sounds like the engine and / or transmission mounts are worn allowing the engine to shake. The issue with the transmission possibly slipping is when the engine RPM's tend to rise up and the vehicle tends to...

A clogged catalytic converter will cause the performance of the engine to suffer. It will run rough, could begin to misfire or lose power, and the gas mileage will suffer. A clogged catalytic converter can also cause engine damage, and...

Stock wiper blades are pretty generic in terms of quality. Most manufactures choose cost over quality when it comes to wiper blades. If you want a dependable long lasting wiper blade I recommend rain x latitude blades. I've had a...

The ABS system has several components that it relies on to operate properly, both hydraulic and electrical. Any qualified technician can perform repair work on the system and I strongly suggest that one performs an inspection to prevent replacing unnecessary...

Hello. Technically, yes, it can be proven by chemical analysis. This would most likely have to be a forensic investigation so obviously you would have to send a sample of the fluid to a laboratory that has a capability in...

It is not normal to have the ball joint welded to the vehicle. All factory welds are clean and painted like the chassis, so it should be easy to tell if it was a weld that was done afterwards. This...

The rattle is most likely coming from a faulty motor mount on the passenger side. The motor mount allows the engine to vibrate and hit metal to metal. Your vehicle should be put up on a lift while in park,...

Starting your engine is not as simple as turning the key and cranking it. There are several things that you should do before hand to ensure safety for both you and your passengers, and those around you. Here’s what you...

Based on the information you gave, it sounds like a possible fuel starvation issue, caused by a partially blocked, in-tank fuel filter or a crack in the fuel pump housing. The remedy would be to replace the fuel pump assembly...

Yes, but a Rav 4 without a doubt would outlast it by far. I'd buy the Rav 4. They are going to last longer. Hondas used to be really solidly built, but they've gone downhill in the last decade, decade-and-a-half....

The windshield wipers provide visibility when you are driving in wet weather. To turn on the windshield wipers, pull the wiper lever (located on the right side of the steering column) down. If the lever is lowered to the first...