Popular questions

Hi there. Typically, when the engine management light comes on, there is a correlation issue between the APP (accelerator pedal position) sensor and electronic throttle control TPS (throttle position sensor). When this occurs, the PCM (powertrain control module) puts the...

Hi there. There is a timing problem with your engine. Check the vacuum advance to see if its advancing when the engine is at a higher rpm. Also check the spark plugs and wires for if they are burned but...

It is possible that the quality of the rubber in the bushings for the shocks could not be as good as what the original shocks had. When bushings rub against the both that secures them to the vehicle this can...

There is not much of a break in period needed for your vehicle. But, there are a few things you can do to ensure that you start your vehicle working properly. To break in your vehicle. Do not drive...

YourMechanic does not offer transmission/engine replacement or swap services. However, here is some advice. first of all, if it's possible to trade the automatic transmission-equipped vehicle for a similar vehicle with a manual transmission, you will save yourself a lot...

Your car is equipped with automatic door locks to help provide better safety and security. Here’s how they work: All the doors will lock once you pass 15 MPH. All the doors will unlock once you turn the ignition...

I would recommend searching around an online forum to see if anything like this has been done before. You could start with a google search for 1995 Toyota 4runner engine swap. This will likely lead you to multiple sources of...

Hi there. Unfortunately, replacing an ECM is not a job that a mechanic can do unless they have access to vehicle specific software updates to program the ECU; which is very rare. The best option is to contact a dealership...

Hi there. Your question for replacement cost of your vehicle's PCM (powertrain control module, is difficult to answer (new, remanufactured, used). Typically, the PCM is not a component that fails, and will most likely require programming once replaced. It could...

Hi, and thanks for contacting YourMechanic. First of all, the mass air flow (MAF) sensor requires its screen; the air registering through the sensor is monitored with the elements in the screen. By removing the screen, you actually destroyed the...

It is possible that this could be normal depending on how severe the noise is. I would recommend taking the vehicle back to the place that you bought it and explain the situation to them. If there is an issue...

Hi there. It really depends on the location of the motor (meaning if it's installed in the vehicle or loose and on an engine stand), that would factor into the price and whether this is a project one of our...

Hello. There is a fuel level gauge on the fuel pump and it reads the amount of gas that is in the fuel tank. It sounds like this gauge has broken on your fuel pump. The gauge cannot be repaired...

A rough idle may be caused by many different things such as low fuel pressure, low voltage to the fuel injectors, dirty fuel injectors, a vacuum leak, a faulty Oxygen sensor or a dirty or failing idle air control valve....

First thing you want to do on a Civic is check the valve lash. Check the adjustment for the mechanically adjustable valves. If the valves are off adjustment on Hondas they will do exactly what you are describing. The...

Hi there. The P0033 OBD-II error code is a generic code that typically indicates a problem with the Turbocharger or Supercharger Bypass Valve Control Circuit. In most cases, the reason the code is triggered is due to a vacuum...

The most common causes of overheating include low coolant level, a faulty thermostat, a plugged radiator, a faulty radiator pressure cap, collapsed hoses, non functioning cooling fans, and a faulty water pump or drive belt. Certain engine faults, such as...

The oxygen sensor heater is integral to the sensor assembly itself. It is not separately serviceable. If the heater tests bad, the entire sensor is replaced as an assembly. In your case, P1193 refers to an oxygen sensor which is...

If you are certain that the BCM has failed and you intend to get one from the junkyard anyway, I would recommend simply giving it a try. If it works, problem solved. If it does not work, it is very...

Hello - this is correct. There is a transponder chip inside your old key that is programmed already to your in-car receiver. Disassembling the old key, remove the chip, and installing it in your new key (discard or save the...

This may suggest a failing voltage regulator. The voltage regulator is a unit that regulates the charging of the battery by the alternator. When the voltage regulator is not working properly, this may result in the alternator allowing too much...

Depending on where the water is located you could have a leak in a weatherstrip seal on a door or trunk, a windshield, or the rear glass. There are instances where the weather stripping on the body panels fail. There...

There would need to be a few checks to be done first. See if there is proper fan operation. Does the fan come on after the vehicle reaches about 220 degrees on the gauge? If the fan comes on and...

Hi There, Depending on how badly the threads are stripped, they may be repairable with a Heli Coil, however this would have to be evaluated on a case by case basis as this does not wok for all situations and...