Good morning I drove my car yesterday and came home and p...


Good morning I drove my car yesterday and came home and parked up this morning my car won’t start and the oil light came on Mechanic's Assistant: Just to clarify, what are the exact lights you're talking about? The oil li...

Good morning I drove my car yesterday and came home and parked up this morning my car won’t start and the oil light came on Mechanic's Assistant: Just to clarify, what are the exact lights you're talking about? The oil light Mechanic's Assistant: What is the make/model/year of your car? Toyota belta 2009 Mechanic's Assistant: Are you fixing your vehicle yourself? What have you tried so far? I tried adding oil still no help the oil is very dark in color I wondering if the oil needs changing

Automotive Expert
Hello! I'm Nick from Kansas. I would be more than happy to help you with your issues. I'll do my best to get you the answers you're looking for. I help many customers so I will respond as soon as I can. Let's see if we can figure out what is causing the problem. I would start by changing the oil if it is very dark in color as it should be an amber color. What is the level on the dipstick when you read the oil level of the [engine](/topics-engine-toyota/)?
Automotive Expert
Hello, I hope you have fixed the issue on your Toyota, if you have any other issues please contact me so we can get it taken care of! Thanks so much.

What others are asking

Steering wheel shaking
Hi there. It sounds to me that you have warped brake rotors. This problem occurs when your brakes heat up to a point where the pressure exerted from the tightened lug nuts bend your rotors. When you press your brakes,...
What is po322 code for a 2002 2.0 jetta 2002
Hello. Your P0322 code is related to the crank position sensor circuit signal. The crank position sensor is located at the rear of the engine and is a common failure. Other possible causes are wiring and engine computer issues. An...
poor acceleration check engine
You will want to have the catalytic converters checked. The 540's are notorious for the catalyst inside the catalytic converters breaking apart (https://www.yourmechanic.com/services/catalytic-converter-replacement) from the outer wall of the assembly and rattling around, especially upon take off. This will also...
Excessive oil burning - 1986 Buick Electra Station Wagon
Hello. If the PCV system is not hooked up correctly, this will cause excessive oil burning. This needs to be checked and repaired first. If the PCV system (https://www.yourmechanic.com/services/positive-crankcase-ventilation-pcv-valve-replacement) is working then the issue is more than likely the piston...
Engine whines, knocks, and has slow acceleration
Hey there. I would suggest you have a mechanic come and listen to the noise (https://www.yourmechanic.com/services/car-is-making-a-noise-inspection) and verify the noise you hear. The engine may be making normal noises. You may be hearing the idle control and air pump noises...
What other damages occur when the idler pulley freezes?
An idler pulley will never prevent an engine from ever running again. An idler pulley just has a ball bearing inside of it that can dry out over time causing it to get hot. If the issue is not resolved...
Where would a GPS be place on my car
A GPS unit would be installed under the dash on the left side most likely. There are many types and models that can track your movements. Some will even mark every few seconds where the car has gone and even...
I just changed the transmission with a rebuild from the transmission shop and I followed all the directions an it still doesn't work
Hello. Yes, problems with the transmission controller can prevent the transmission from going into gear. Double-check the fluid level to be sure it is at the proper level. Also, double-check the hydraulic pressure from the transmissions input pump to be...
When stopped at a light rpm will dip from 600 to 500 can then move back up
Although the idle speed can be adjusted, the idle speed of the engine is optimized by the manufacturer for maximum performance and economy of operation. In practice, therefore, there is no value in making any adjustment. Low and/or unstable idle...