Skip the auto shop - Our mechanics make house calls

Q: Smart Entrance Control Module needs replacing

asked by on

I believe my Smart Entrance Control Module needs to be replaced. I am having issues with my interior dome light, defrost light, auto locks, and keyless entry not working.

A: The SECM may be ok. It may have a power iss...

The SECM may be ok. It may have a power issue due to a blown fuse or relay. The SECM is an expensive part and may require factory level programming. I suggest having a qualified technician fully inspect your vehicle's electrical system before condemning the SECM.

Was this answer helpful?

Need advice from certified mechanic? Get help now!

Over 1000 mechanics are ready to answer your question.
The statements expressed above are only for informational purposes and should be independently verified. Please see our terms of service for more details

Ask a Mechanic
(100% Free)

Have a car question? Get free advice from our top-rated mechanics.

Ask A Mechanic
Over 10,000 questions answered!

Get an instant quote for your car

Our certified mechanics come to you ・Backed by 12-month, 12,000-mile guarantee・Save up to 30%

Get a quote

What others are asking

Q: Keyless entry reprogramming and troubleshooting.

Hi there. Check the terminals 4 and 8 for power. If there is no power to any of the terminals, then check the fuse box for any blown fuses to the door lock cylinders. Also, check the door lock switch...

Q: the bolt size at the top fixed chain guide 2.2 ecotec

Hello. The timing chain guide bolts on this engine are an M6 x 1.00 30mm. You will need to remove the rest of the broken bolt from the engine prior to replacing these. The replacements are available over the internet...

Q: What has stopped working cvc axle or transmission

The popping noise on turning is typical of failed outboard CV axle joints. It is possible the joints did finally break, thus accounting for the lack of movement. If you jack up the front wheel (just one side at a...

Related articles

P0052 OBD-II Trouble Code: HO2S Heater Control Circuit High (Bank 2 Sensor 1)
P0052 code definition HO2S Heater Control Circuit High (Bank 2 Sensor 1) What the P0052 code means This code is seen when the Engine Control Module (ECM) tries to control the...
P0240 OBD-II Trouble Code: Turbocharger Boost Sensor B Circuit Range/Performance
P0240 code definition Turbocharger Boost Sensor B Circuit Range/Performance What the P0240 code means P0240 is an OBD-II generic code triggered when the Engine Control Module (ECM) detects the intake boost...
P2103 OBD-II Trouble Code: Throttle Actuator Control Motor Circuit High
P2103 means there is a fault with the throttle actuator control motor circuit, likely due to a defective electrical component or part.