2004 Cayenne Porsche s


2004 Cayenne Porsche s Mechanic's Assistant: Are you fixing your Cayenne yourself? What have you tried so far? Myself Mechanic's Assistant: Anything else you want the Mechanic to know before I connect you? WAS ch...

2004 Cayenne Porsche s Mechanic's Assistant: Are you fixing your Cayenne yourself? What have you tried so far? Myself Mechanic's Assistant: Anything else you want the Mechanic to know before I connect you? WAS changing fuses and I started watching machine immobilizer

Automotive Expert
Hello and thank you for using JustAnswer. My name is \*\*\*\*\* \*\*\*\*\* I will do my best to assist you. During this conversation you will be given an automated offer for a phone call. You may accept or decline that offer.I don’t personally offer this service so if you take this another tech may call I’m sorry that you’re having trouble with your vehicle. I will do my best to help you resolve them. Please understand that I do not know your knowledge or capabilities so I may need to ask questions to find out basic information to help solve your specific problem. My aim is to give you the best service possible and to help you. If you have any questions or concerns, please don’t hesitate to let me know. Sometimes it may take a moment for me to respond because I may have to look up information about your concern. I appreciate your patience and will provide responses as soon as possible. Did you have the key in the ignition while you were replacing fuses?
Automotive Expert
HI The best I can tell you at this point is to have the immobilizer module scanned for fault codes and repaired or reprogrammed as needed. If you can get me the fault codes I can help in any testing needed Thanks for using Just Answer and letting me help you. I hope I provided what you needed. If you find more help is still needed, let me know by listing out any remaining questions you have on this concern. I hope the remainder of your day is well.

I'll get at you and thankx
Automotive Expert
you are welcome

What others are asking

Cigarette lighter not working.
It is very likely that the fuse for the cigarette lighter circuit has failed. This is not uncommon. There is also the possibility that the actual cigarette lighter receptacle has failed as well. I would ask for help from one...
Vehicle makes rattling noise when idling
Based upon the information provided, an inspection of the drive belt and air conditioning system should be performed. The squealing noise indicates your drive belt is under strain. If the belt breaks, you will not be able to drive your...
Bad key or ignition switch
Hi, the car is still fairly new and it is rare for the ignition switch to fail so early. Does the security light on the dash light up and flash when trying to start the car? This would mean the...
Car overheated while idling. What is wrong
There are a few faults that will cause your 2013 Hyundai Elantra to overheat when idling. The most common would be the electric fans not functioning. When air is flowing over the radiator the car works fine, but when the...
I think my clutch or clutch master cyclinder went out
Hello - it sounds like the clutch hydraulics are not functioning properly. Check for adequate fluid level first - the clutch fluid reservoir is near the brake fluid reservoir on the firewall (driver side). If the fluid level is low,...
I think the anti-lock security on my car is active and it doesn't start.
Hi there. Look at the anti-theft system on the vehicle and see if the light is flashing. If the light is flashing, then remove the battery cables and leave them off for 13 minutes. While the cables are off, put...
Why does my Transmission pops out of gear
Hello. Popping out of gear is a common problem when it comes to manual transmissions. The most common reason a manual transmission would jump out of gear is due to low or contaminated fluid, worn synchronizers inside the transmission, or...
driver side axle repair seal is leaking honda crv 2014
If you are referring to the CV axle seal that is within the side case of the transaxle (i.e., transmission fluid is leaking), the service to request to get that leak repaired is axle shaft seal replacement (https://www.yourmechanic.com/services/axle-shaft-seal-replacement). It is...
No crank no start. Crankshaft is stuck. Could it be the crankshaft sensor? 2007 Dodge Charger
Hi there - if you are unable to rotate the crankshaft, that is a serious problem. Perhaps the timing chain has broken, and jammed between the crankshaft sprocket and the timing chain cover? Check for problem codes, whether the Check...