Q: overheating problem

You can very easily make a hands-free phone call using your voice recognition system, as long as your phone is paired: 1. Press the voice command button. 2. When the system says “Ready”, and then offers a tone, say “Call”...

Hi. The body control module (BCM) takes input from the door lock switches and in turn, controls the door lock actuators. These actuators lock and unlock your doors. Looking at the wiring diagram for your vehicle, I don't see that...

Hello. This simply means that the vehicle needs maintenance. If I knew the mileage I could tell you what it may be needing. It can be an oil change, or a transmission service, or just about any other maintenance item....

This may be likely related to a fuel pump issue (https://www.yourmechanic.com/services/fuel-pump-replacement) or lack of fuel pressure. Low fuel pressure is something that can cause your car to struggle to idle (https://www.yourmechanic.com/services/car-idle-is-rough-inspection) or even stall (https://www.yourmechanic.com/services/car-is-stalling-inspection) when driving. This will also...

Hello. This is completely normal operation of the vehicle's cooling system. The top radiator hose (https://www.yourmechanic.com/services/radiator-hose-replacement) should always be warmer than the bottom. As coolant flows through the water pockets in the engine it picks up heat, and it is...

Hi there. The rear wheel being out of alignment, could be the result of a bent strut assembly (https://www.yourmechanic.com/services/strut-assembly-replacement), a bent trailing/control arm (https://www.yourmechanic.com/services/control-arm-assembly-replacement), a bent bearing knuckle and/or bent rear subframe. Replacing components without diagnosis can be expensive and...

This may be a sign of a vacuum leak. A vacuum leak can be one of the most frustrating and difficult problems to diagnose. High idle speed is a common sign and stalling is another. Confirmation of an engine vacuum...

Hi there. Absolutely, there is a chance that there could be a damaged timing belt or it has jumped time. However, there is also the possibility that the debris has damaged the crank/cam position sensors. With a capable scan tool/...

Hi there. When changing out the ball joints, you don't need to change the control arms if you have a replacement ball joint. However, if you are wanting to replace the bushings and the ball joint, then you may get...