Q: Myride

asked by on

Can the manifold gasket be reused after we remove it to replace #2spark plug?

My car has 64000 miles.
My car has an automatic transmission.

If you are taking off the manifold then a new gasket should be used or an exhaust manifold leak may happen after reconnected.

Was this answer helpful?
The statements expressed above are only for informational purposes and should be independently verified. Please see our terms of service for more details

Get an instant quote for your car

Our certified mechanics come to you ・Backed by 12-month, 12,000-mile guarantee・Fair and transparent pricing

Get a quote

What others are asking

Q: What cause a catilac converter in 2009 nessain murnao go bad

There can be a few different reasons for a catalytic converter to fail. Your engine running too rich or lean or coolant in exhaust from a blown head gasket can cause failure. Also a defective converter that breaks apart and...

Q: Car won't stay charged

Typically, when a battery has failed internally, it stops holding a charge for as long as it used to. You will want to run an inspection on your battery, alternator and starter, and check to make sure that there are...

Q: My Cadillac CTS displayed a message saying trans hot engine idle what could the cause of that be?

Check the transmission fluid and see if its low or too high. Low or too high transmission fluid will cause the transmission to overheat. The transmission temperature sensor will pick up this condition and keep the vehicle from going into...

Related articles

Rules of the Road For Iowa Drivers
Driving on the roads requires knowledge of the rules, many of which are based on common sense and courtesy. However, even though you know the rules in...
What are the Car Pool Rules in Hawaii?
Hawaii is widely regarded as a land of vacation and relaxation, and as such, its scenic roads and routes are far better known than the state’s freeways. But, as with all...
P2428 OBD-II Trouble Code: Exhaust Gas Temperature Too High Bank 1
P2428 code definition A P2428 trouble code signifies that the PCM has detected a problem in the exhaust gas temperature sensor circuit in bank 1, which subsequently contains the number one...