Q: I recharged the battery in my truck, but it still won't start.

asked by on

My pickup truck will not start, even after I recharge the battery.

I would have the battery load tested to see if it is bad. When the batteries get old they will not hold a charge and can not crank the car.

Was this answer helpful?
The statements expressed above are only for informational purposes and should be independently verified. Please see our terms of service for more details
  1. Home
  2. Questions
  3. I recharged the battery in my truck, but it still won't start.

Get an instant quote for your car

Our certified mechanics come to you ・Backed by 12-month, 12,000-mile guarantee・Fair and transparent pricing

Get a quote

What others are asking

Q: Seemingly misfires

Hi...your vehicle has an on-board diagnostic system, albeit the early version known as OBD-I. What I would therefore recommend, to get this engine running condition diagnosed and repaired, is you request a check engine light diagnostic. The trouble codes that...

Q: My check engine light came on and it had code p1151. What could cause that code?

Trouble code P1151 sets if the air/fuel ratio is out of range lean. Vacuum leaks in the intake are a typical cause but if the fault is not found there, there are actually quite a few potential trouble spots including:...

Q: Acts like the battery is low and when i try to start it, lights flicker and tries to turn over

It is very possible that your battery could be completely finished off. I would recommend disconnecting the sound system and installing a new battery in the vehicle to see how the vehicle performs. It is certainly possible that the sound...

Related articles

Rules of the Road For Iowa Drivers
Driving on the roads requires knowledge of the rules, many of which are based on common sense and courtesy. However, even though you know the rules in...
P2428 OBD-II Trouble Code: Exhaust Gas Temperature Too High Bank 1
P2428 code definition A P2428 trouble code signifies that the PCM has detected a problem in the exhaust gas temperature sensor circuit in bank 1, which subsequently contains the number one...
P2103 OBD-II Trouble Code: Throttle Actuator Control Motor Circuit High
P2103 means there is a fault with the throttle actuator control motor circuit, likely due to a defective electrical component or part.