Q: I have a cooling leak for one but it cranks up but but if it runs idle for a while it shake and make noise if I cut it off it migh

The rear outboard head restraints can be removed. To do so, first fold the restraint down by pulling on the fold strap. Then press both Release buttons on the base of the restraint, and pull the restraint straight up.

There may be a problem with the clutch pressure plate, the hydraulic clutch master, or slave cylinder binding. The clutch is the most likely problem, and would need to be inspected to be sure. I recommend that you have a...

If the vehicle is leaking brake fluid, I would stop driving it, and have it serviced as soon as possible as your braking system is essential to road safety. Braking systems operate using hydraulic pressure, so any leaks are a...

First of all, cleaning a mass air sensor may not have fixed the sensor and O2 sensors cannot be cleaned. The O2 sensors for bank 1 and bank 2 means that the left and right side of the engine. You...

I wouldn't concern yourself with the timing of your cars symptoms. When a car fails, I liken it to when a light bulb decides to burn out. It was just its time. Everything will eventually fail. I also would strongly...

What aspect of it do you need identified? To start, the parking brake and the emergency brake are the same part. Those are the two of the names given to the additional brake or hand brake as it is also...

You do not have to remove or replace the timing belt in order to replace the water pump.

Common causes of engine stalling and rough idle include a faulty mass airflow sensor, faulty engine coolant temperature switch/sensor (typically at cold start only), worn spark plugs, wires or defective ignition coil(s), inadequate fuel delivery or pressure (clogged fuel filter,...

Hi There, It sounds like you may have a faulty thermostat or potentially a cooling fan that may not be cycling on and off properly. As you know, the thermostat regulates the flow of the coolant in your car's engine...