Q: I had the tie rods and upper control arms replaced on my truck and it still squeaks.

asked by on

had the tie rods and upper control arms replaced last week on my truck and it still squeaks and had a front end alignment right after recent repair.

The statements expressed above are only for informational purposes and should be independently verified. Please see our terms of service for more details
  1. Home
  2. Questions
  3. I had the tie rods and upper control arms replaced on my truck and it still squeaks.

Get an instant quote for your car

Our certified mechanics come to you ・Backed by 12-month, 12,000-mile guarantee・Fair and transparent pricing

Get a quote

What others are asking

Q: Q: bad tie rod end

When you say a bad tie rod end, this means that it is loose. This means that it may come off and you would loose steering control. If it is bad enough for you to ask for advice, then you...

Q: Squealing loudly when driving up to 60 km an hour

Hello, the noise you are hearing may be brake system related. The brake pads located by the tire area have audible sensors to indicate the pads need to be replaced. I recommend getting a brake inspection done as soon as...

Q: Car shudders whenever I brake at a speed of 60-70 mph

The control arm bushings need to be checked. Worn out control arm bushings will change the toe setting at higher speeds, causing the front tires to fight one another. It will also cause a feathering wear to occur on the...

Related articles

P0052 OBD-II Trouble Code: HO2S Heater Control Circuit High (Bank 2 Sensor 1)
P0052 code definition HO2S Heater Control Circuit High (Bank 2 Sensor 1) What the...
How to Avoid Back Pain in a Car
If you have back problems, sitting in a car for an extended period of time can be excruciating. Even without back problems, you could experience discomfort and soreness from...
P2428 OBD-II Trouble Code: Exhaust Gas Temperature Too High Bank 1
P2428 code definition A P2428 trouble code signifies that the PCM has detected a problem in the exhaust gas temperature sensor circuit in bank 1, which subsequently contains the number one...