Q: I got my serpentine belt replaced on my 2002 Q45 and now my car wont start. This never happened before. 2002 Infiniti Q45
I replaced my serpentine belt because it was recommended when I got my oil changed. I drove it with one day no problems. Now my car wont start
My car has 180000 miles.
My car has an automatic transmission.
The statements expressed above are only for informational purposes and should be independently verified. Please see our
terms of service
for more details
Get an instant quote for your car
Our certified mechanics come to you ・Backed by 12-month, 12,000-mile guarantee・Fair and transparent pricing
What others are asking
vacuum hose collapse for brake booster
No it is not supposed to collapse. The hose has most likely got soft from oil or other contaminants and should be replaced. If you find the hose has fluid in it and it is brake fluid, then your brake...
Battery or alternator problems?
Hello, thanks for writing in. If the car runs fine once it is started, then the alternator should be fine. I would replace the battery (https://www.yourmechanic.com/services/battery-replacement) because it is not holding a charge. Once it is replaced I would check...
Engine rpm not steady at 40-55 mph
This is a common sign of a failing throttle position sensor (https://www.yourmechanic.com/services/throttle-position-sensor-replacement). The throttle position sensor (TPS) is a sensor used to monitor the throttle position of a vehicle. The sensor is usually located on the butterfly spindle/shaft so that...
Have codes p0068 and p2610 on 2011 Ford Fiesta, MAF sensor was replaced 7 months ago, intermittent stall when stopping but restart
I doubt these two codes are connected. The 2610 is a fault where the engine control module (ECM) cannot detect the power off cycle when the engine is turned off; meanwhile, the other code has to do with a throttle...
My car shows trouble codes P0133 and P0420
Hi there: It appears as if you've got a lot of miscommunication going on with your mechanic. Here are a few basics. First, anytime an error code is triggered, such as the P0133 OBD-II code (https://www.yourmechanic.com/article/p0133-obd-ii-trouble-code-o2-sensor-circuit-slow-response-bank-1-sensor-1-by-blake-griffin) the issue needs to...
Rattling noise low rpms
Hello there. Thanks for the video. Unfortunately, it's nearly impossible for us to determine where this noise is coming from, as it's hard to tell in the video itself. The best thing we can suggest is to have one of...
Does jacking up a car in one corner damage the chassis or sway bars.
If you use ONLY the jack, and support points, specified in the Factory Service Manual (FSM), no damage will occur. These contact points might also be specified in your owner's manual and shown there in illustrations. Please note that if...
My dodge Dakota revs rpms extremely high when I start the truck vacume lines are good what else might it be?
Hi there. Typically a high engine RPM is caused by a vacuum leak or idle control valve failure. Although you've indicated that the vacuum lines and throttle control sensor are good, you might want to verify all vacuum line connections...
can't find crank sensor on VW CC 2010... any ideas?
The crankshaft sensor is on the side of the motor near transmission directly in line with the starter on side of engine block.
Related articles
A Guide to Motor Oil Additives
Motor oil contains various additives to make it perform better. Conventional and synthetic oils both contain additives which help prevent engine wear.
How to Check a Faulty Timing Belt Tensioner
The timing belt (https://www.yourmechanic.com/parts/timing-belt-kit) is a critical part of the automotive engine; if it breaks, it can cause some serious damage. The...
Understanding the Infiniti Maintenance Required and Service Indicator Lights
Car symbols, or dashboard lights, are a car service reminder. The Infiniti Maintenance Required light indicates when your car needs service.
Browse other content
Services
Cities
Maintenance