Q: I bought a used 1991 honda civic 3 door hatchback and when I start my car it accelerates on its own. What is wrong with it?

The hood covers the engine and other important mechanisms. To get to certain features on your vehicle, you will need to open the hood. To open the hood. Pull the hood release handle on the driver’s side. Release the auxiliary...

Hi, thanks for the question. This is a serious problem and you should shut the car off immediately to risk damaging your transmission further as it may already be to late. The loss of fluid and your car not moving...

Hi. There are two 30 amp fuses that control the rear seats. Fuse 5 controls the left and fuse 12 controls the right rear folding seat. These fuses will need to be checked along with the relays that control each...

Hello. The A.I.R. system is an emissions system that is designed to inject air into the exhaust manifold to help with the combustion of any unburned fuel before it reaches the catalytic converter, resulting in cleaner emissions. In order to...

Hi there. The P0441 trouble code (https://www.yourmechanic.com/article/p0441-obd-ii-trouble-code-evaporative-emission-control-system-incorrect-purge-flow-by-spencer-clayton) will be seen when the ECU has detected incorrect purge flow in the Evaporative (EVAP) emission control system. When the purge flow is determined to be faulty, a Check Engine Light is set...

Hello, thank you for writing in. The crankshaft position sensor would cause the vehicle not to start if there was an issue with it. With that being said, there may be a variety of other issues due to the water...

The power steering pump pressure switch is located on the pressure hose just before the connections to the rack and pinion steering system. If you need further assistance with your power steering system (https://www.yourmechanic.com/services/power-steering-fluid-service), then seek out a professional, such...

What you are describing sounds like a wheel bearing (https://www.yourmechanic.com/services/wheel-bearings-replacement) that may be starting to fail. A wheel bearing will usually fail due to pitting or small damage on the surface of the rollers or the bearing race. Both the...

Hi there. The headlights for Acura's tend to be rather pricey for some reason I still haven't figured out yet. However, you can request to have one of our professional mobile mechanics come to your location and complete a headlight...