Q: I accidentally adjusted my side view mirror by physically touching the mirror. Is that okay?
I accidentally adjusted my side view mirror by physically touching the mirror. Is that okay?
My car has an automatic transmission.
The statements expressed above are only for informational purposes and should be independently verified. Please see our
terms of service
for more details
Get an instant quote for your car
Our certified mechanics come to you ・Backed by 12-month, 12,000-mile guarantee・Fair and transparent pricing
What others are asking
How do I adjust the trailer towing mirrors?
Your car may be equipped with trailer towing mirrors that give you better visibility when you are towing long or wide loads. To put your mirrors in trailer towing mode, hold them with your hands, and rotate them counter-clockwise, such...
How do I make a phone call with the voice recognition system?
You can very easily make a hands-free phone call using your voice recognition system, as long as your phone is paired: 1. Press the voice command button. 2. When the system says “Ready”, and then offers a tone, say “Call”...
Car misfires after distributor, rotors, plugs, plug wires replacements. 1999 GMC Savana 3500
Although the person who serviced your vehicle the first time did not repair the issue, I think he might be correct about the fact that it could be an intake manifold gasket (https://www.yourmechanic.com/services/intake-manifold-gaskets-replacement) or a fuel pump issue (https://www.yourmechanic.com/services/fuel-pump-replacement). You...
No heat after adding coolant and thermostat almost to H
Hello. If the coolant was that low then that will cause the heater to not work. The most important thing at this time would be to determine where the coolant went. For it to be this low that means it...
Gasoline smell in car
You have to first exclude the possibility that the shop somehow spilled gasoline in the interior of the vehicle and/or sat in the car with gas on their clothes or placed any gas contaminated "stuff" (rags) in the vehicle or...
Oil presure light
Hello. You should not have to reset anything related to the oil pressure after servicing the vehicle. If the light is coming on then that is a sign that there is an issue with the engine's oil pressure or an...
Where is the Mass AirFlow (MAF) sensor located on this car? 2005 Saturn L300
Hello - the mass airflow (MAF) (https://www.yourmechanic.com/question/what-does-the-mass-airflow-sensor-do) sensor is the black plastic cylindrical tube with an electrical harness that goes into the air filter housing on your engine air intake system. I would check for problem codes first however, as...
Truck wont shift into third gear after going over 25 mph 2005 Ford Expedition
Hello - most likely the direct clutch in your transmission (https://www.yourmechanic.com/question/does-an-automatic-transmission-have-a-clutch) has failed, and a transmission rebuild is in order. Less likely, but possible - is a throttle position sensor failure. I would recommend a transmission inspection (https://www.yourmechanic.com/services/gears-slipping-when-accelerating-inspection) by a...
When I am accelerating, my car makes a squealing noise
You should have the serpentine belt checked to see if belt is in need to be replaced or tensioner is causing slipping of belt. If it is replace tensioner and belt.
Related articles
A Buyer’s Guide to the 2012 Nissan Altima
While While it may not be quite as modern and sporty looking as some other models, the 2012 Nissan Altima is still a huge contender in the mid-size sedan category. With both four- and six-cylinder options and a CVT (continuously...
The Best Used Cars to Buy If You're a Farmer
If If you're a farmer, you know that what you need isn’t a used car – it’s a used pickup truck. How else are you going to haul around hay, implements, garden produce, fertilizer, and all the other things you...
The Best Used Cars to Buy If You're a General Contractor
If If you're a general contractor, you probably aren’t in the market for a used car. More likely, you’re looking for a pickup truck, because you need to haul equipment and supplies to various job sites. Most contractors will likely...
Browse other content
Services
Maintenance