Q: How to remove door panel to repair power lock and find rattle sound

asked by on

I need to know how to remove the door panel in order to repair the power lock and find a rattle noise. Thank you.

The door panel is held on by a couple of screws and door clips. You can find some illustrated instructions in this article.

Was this answer helpful?
The statements expressed above are only for informational purposes and should be independently verified. Please see our terms of service for more details
  1. Home
  2. Questions
  3. How to remove door panel to repair power lock and find rattle sound

Get an instant quote for your car

Our certified mechanics come to you ・Backed by 12-month, 12,000-mile guarantee・Fair and transparent pricing

Get a quote

What others are asking

Q: electrical issue and the tail light bulbs keep popping.

Hi there. Sounds like there is a few different electrical issues with your vehicle. Check the door courtesy light switch for a loose ground or a short in the wire. A loose ground will cause the interior lights to work...

Q: There is a sound noticed when fully turned position in both right and left and forward and backward direction. Grinding sound.

Good question and you are correct. It sounds like it is your power steering pump. There is only one noise a bad power steering pump makes, and no other part will make the same grinding noise as the power steering...

Q: Fuel Pump shuts off when filling

This is likely related to your EVAP emissions system and something called a purge solenoid. The EVAP system prevents fuel vapors from the fuel tank from escaping into the atmosphere. The EVAP system collects and temporarily stores the fuel vapors...

Related articles

P0052 OBD-II Trouble Code: HO2S Heater Control Circuit High (Bank 2 Sensor 1)
P0052 code definition HO2S Heater Control Circuit High (Bank 2 Sensor 1) What the...
What are the Car Pool Rules in Hawaii?
Hawaii is widely regarded as a land of vacation and relaxation, and as such, its scenic roads and routes are far better known than the state’s freeways. But, as with all...
P2103 OBD-II Trouble Code: Throttle Actuator Control Motor Circuit High
P2103 means there is a fault with the throttle actuator control motor circuit, likely due to a defective electrical component or part.