Q: How do you install a front license plate?

asked by on December 14, 2015

How do you install a front license plate?

If you live in a state that requires license plates on the front and rear, or if you want to install a vanity plate on the front of your car, you’ll just need to follow these simple steps:

  1. Locate the two dimples on the front license plate finisher.

  2. Use the two provided screws to mount the plate bracket.

  3. Install the plate.

The statements expressed above are only for informational purposes and should be independently verified. Please see our terms of service for more details

Get an instant quote for your car

Our certified mechanics come to you ・Backed by 12-month, 12,000-mile guarantee・Fair and transparent pricing


Experienced Mechanic?

Earn up to $70/hr

What others are asking

Car making loud clicking noise.
Hello. The 2.4 liter engine in your car does have a few common issues. It is most commonly caused be a timing chain problem. When the timing chain stretches or if a tensioner fails you will get this noise and...
Car leaking gas
A fuel leak can be a very dangerous situation. Your car needs to be inspected and fixed as soon as possible. Fuel leaks can come from a cracked fuel tank or damage on any of the lines that run the...
Door locks on and off on and speedometer dial fluctuates
I would question the diagnosis for the dealer to show you the reason to get the cable replaced and why the cable is so expensive. Have them break down the parts and labor in the quote. I show about an...
How can I access the rear trunk?
Hi and thanks for your question. The release levers for the trunks are manual and there is a "lock out" plate to prevent them from being released when the car is locked or the driver's door is closed. Use a...
Car is skipping while idling and while driving. Added new spark plugs and wires and it's still doing the same thing
Hey there. The coil pack is one of a few different components that can contribute to a misfire (https://www.yourmechanic.com/services/engine-is-misfiring-inspection). The ignition module which sits beneath the coil pack can be at fault. Other components can be a faulty fuel injector...
Hi I have a chevy j1 2010 model. My remote is jamed and I can't start my car. It shuts off my fuel how can I reset my alarm to start the vehicle.
Hi there. The remote will need to be repaired or replaced and then the new remote would need to be programmed to match the computer system in your vehicle. Then your vehicle will start up properly. If you need further...
Whitish marks on car. Need to find a way to make the paint job look better without getting whole new one
If the damage to the paint is on the surface you can use a good past wax or mile compound to rub off the marks and follow it with a good wax. If the paint has been damaged then a...
I have a 1997 Chevy pickup truck with a vortex motor in it will not fire up unless I started up and starting fluid but runs great
You will need to have the fuel pressure tested to see if it is too low to open injectors and have injectors cleaned or replaced if cleaning does not get them cleaned.

Related articles

A Buyer’s Guide to the 2012 Volkswagen GTI
The The 2012 Volkswagen GTI has a good suspension offering a smooth drive on any type of pavement. The interior feels luxurious because of the high quality materials used for the seats and the overall unique design of the vehicle....
A Buyer’s Guide to the 2012 Audi Q7 TDI
If If you’re looking for a luxury crossover that has all the high-end amenities and plenty of power and fuel economy, you’ve found it in the 2012 Audi Q7 TDI. Fans of the Q7 will immediately recognize the overall look...
A Buyer’s Guide to the 2012 Land Rover Range Rover Evoque
When When most people consider the Land Rover, the words compact and fuel efficient don’t enter into the equation. However, the 2012 Land Rover Range Rover Evoque is just that – a compact SUV that also focuses on being just...