Q: Q: How do I use the windshield washers?

asked by on

How do I use the windshield washers?

The windshield washers provide you increased visibility by washing your windshields. To wash the windshields, press in on the end of the Windshield Wiper lever. If you press this button briefly, the washers will run for three swipes of the wiper. If you press and hold the button, the washers will run continuously for up to 10 seconds.

Was this answer helpful?
The statements expressed above are only for informational purposes and should be independently verified. Please see our terms of service for more details
  1. Home
  2. Questions
  3. Q: How do I use the windshield washers?

Get an instant quote for your car

Our certified mechanics come to you ・Backed by 12-month, 12,000-mile guarantee・Fair and transparent pricing

Get a quote

What others are asking

Q: windshield wipers will not turn off.

Hi there. Thanks for writing in about the windshield wiper issue on your 2013 Chrysler 200. It's pretty rare that this happens with a newer vehicle like yours, but there are a few potential issues that might be causing this....

Q: How Do I Clean My Car Mirrors?

Cleaning your mirrors, or any glass for that matter, can be done with good results or poor results. There are some basic things to remember when cleaning your mirrors. This works for your windows too. First of all, do this...

Q: How do I extend the remote start?

Unless set otherwise, your engine will run for 10 minutes after being turned on via remote start. After 10 minutes, if the car has not been operated, the engine will turn off. You can extend the remote start time at...

Related articles

How Do Power Car Windows Increase Passenger Safety?
Power windows are responsible for approximately 2,000 emergency room visits every year. When a power window closes, it exerts enough force to bruise or break bones, crush fingers, or restrict an airway. Though...
P0240 OBD-II Trouble Code: Turbocharger Boost Sensor B Circuit Range/Performance
P0240 code definition Turbocharger Boost Sensor B Circuit Range/Performance What the P0240 code means P0240 is an OBD-II generic code triggered when the Engine Control Module (ECM) detects the intake boost...
P2103 OBD-II Trouble Code: Throttle Actuator Control Motor Circuit High
P2103 means there is a fault with the throttle actuator control motor circuit, likely due to a defective electrical component or part.