Q: How do I set the USB in repeat mode?

asked by on

How do I set the USB in repeat mode?

You can set your USB device o repeat mode by using the audio controls. To do so, press the Repeat button. If you hold the button for less than 0.8 seconds, the device will repeat the current song. If you hold the button for more than 0.8 seconds, the device will repeat all of the songs in the current folder. You can turn off repeat by pressing the Repeat button again.

Was this answer helpful?

Need advice from certified mechanic? Get help now!

Over 1,000 mechanics are ready to answer your question.
The statements expressed above are only for informational purposes and should be independently verified. Please see our terms of service for more details

Ask a Mechanic
(100% Free)

Have a car question? Get free advice from our top-rated mechanics.

Ask A Mechanic
Over 10,000 questions answered!
  1. Home
  2. Questions
  3. How do I set the USB in repeat mode?

Get an instant quote for your car

Our certified mechanics come to you ・Backed by 12-month, 12,000-mile guarantee・Fair and transparent pricing

Get a quote

What others are asking

Q: Belts squealing upon startup and when turning.

It could be that your belts are not adjusted properly. The alternator is belt driven, so a correct belt adjustment is required for proper alternator operation. A qualified mechanic, such as one from YourMechanic, will be able to diagnose and...

Q: How do I change the display mode?

The display mode adjusts the display to best fit the lighting. You can adjust the display mode very easily: 1. Press the Setup button. 2. Press the System button. 3. Press the Display button. 4. Press the Display Mode Options...

Q: Noise when driving - clutch issues?

Hi there, thanks for writing in. It sounds like you may have a defective clutch or a transmission input shaft gear problem. If you'd like help looking into it, consider having one of our certified mechanics come to your home...

Related articles

How Long Does a Distributor O Ring Last?
The distributor is part of the ignition system in your vehicle and its purpose is to route high voltage from the ignition coil to the spark plug. The spark plug then...
P2428 OBD-II Trouble Code: Exhaust Gas Temperature Too High Bank 1
P2428 code definition A P2428 trouble code signifies that the PCM has detected a problem in the exhaust gas temperature sensor circuit in bank 1, which subsequently contains the number one...
P2103 OBD-II Trouble Code: Throttle Actuator Control Motor Circuit High
P2103 means there is a fault with the throttle actuator control motor circuit, likely due to a defective electrical component or part.