Q: How do I rewind or fast forward a song on the CD player?

As far as jack stands (https://www.yourmechanic.com/article/how-to-buy-a-good-quality-jack-stand) go, the pin locks are by far the safest if they have thick pins. Once you get the car up and you have that big thick metal rolling pin secured in there, nothing beats...

There are two brake booster vacuum check valves that will stick in cold weather for about a minute. These two valves supply vacuum to the brake booster and will cause reduced power assist to the brakes until they start to...

This could be a variety of things ranging from poor fuel delivery to vacuum leaks. In the case of a vacuum leak, when you step on the accelerator and demand a quick increase in air/fuel flow to the intake system...

It sounds like you may have a fuel level sensor failure. Verify there is fuel in the tank, if possible, to eliminate the low fuel as an issue. Electrical testing (https://www.yourmechanic.com/services/electric-problems-inspection) can be done to determine if the sensor is...

Diagnosing throttle issues is very difficult to do without being on site to complete an exam. However, in some cases, this symptom is caused by a damaged or worn out throttle controller (https://www.yourmechanic.com/article/symptoms-of-a-bad-or-failing-throttle-controller). Throttle Controller is the electronic version of...

If the noise changed when the battery was replaced, I would first suspect the alternator. Sometimes, when a bearing/bushing starts to go bad it will only make noise with the belt installed, as the tension can cause pressure to be...

Hi there. Unfortunately, it is very difficult to find a repair facility you can trust. The knocking/rattle noise (https://www.yourmechanic.com/services/noise-from-engine-or-exhaust-inspection) could be any number of components creating the noise. At this point the engine not cranking (https://www.yourmechanic.com/services/car-will-not-turn-over-inspection) needs to be diagnosed,...

When rotating the crankshaft and turning the engine over, the camshafts will realign after the crankshaft has turned twice. Now, the marks on the timing chains will take around 15 rotations to line up on the timing marks on the...

You may still be in lockout and the security system is keeping you from starting the car. When the car was entered without the key, it no doubt triggered the immobilizer and that will have to be reset. It's might...