Q: How do I adjust the audio settings?

Your car is equipped with electric power steering. The vehicle needs to be checked for codes in the steering system. If there are none present, please contact Hyundai to see if your vehicle is covered under recall #15V100000 for Hyundai...

Unfortunately, if the Oil Light did come on, it is possible that the engine oil was low, and the engine was oil-starved. The oil should be drained in a clean pan, and examined to see if there are metal particles...

I agree with the mechanic that checked it. It needs to have the transmission overhauled. I cannot make the decision if you should get it done or not, since it is a very expensive repair and may exceed the value...

Hi. The first task is to extract the problem codes (https://www.yourmechanic.com/article/how-to-read-and-understand-check-engine-light-codes-by-jason-unrau) which the Check Engine light indicates are present. These codes are most helpful in diagnosing problems with your vehicle. Two different transmissions were offered in the Civic - the...

Hi - your Impreza has a turbocharged engine for enhanced performance. This produces pressurized air for the engine, increasing power. To avoid over-pressurizing the engine, there are boost pressure controls, and a "waste gate (https://www.yourmechanic.com/question/how-necessary-is-it-to-repair-the-wastegate-by-chancey-w)" port to vent over-pressure -...

If the outer bearings in the hub failed too quick then it is caused by lack of enough grease or the bearing was pre loaded too tight when installed or both. Make sure to use a good quality hi temp...

If you used thicker oil than vehicle specified then this can cause problems with the intake variable valve lift system. If you used the wrong oi then change oil and filter again with the proper viscosity oil. If the correct...

You may be feeling the a/c compressor engaging and should have the a/c system checked for problems with the compressor pulley bearing. If a/c is okay then you may have another issue with the water pump or one of the...

Sometimes its easy to get the hardware in a little crooked when changing brake pads, that or a backing plate might have gotten bent. Take the car back to the guy who did your brakes, they should be happy to...