Skip the auto shop - Our mechanics make house calls

Q: Engine whining in 1st gear & 2nd gear

asked by on

Engine whininh in 1st gear & 2nd gear

A: Hello. It is not the engine whining but the...

Hello. It is not the engine whining but the transmission internal bearings that are whining. I would recommend having a mechanic verify the noise is in the transmission and see if the transmission needs internal repairs. Depending on the vehicle and transmission, a fluid change may help reduce the noise.

Was this answer helpful?

Need advice from certified mechanic? Get help now!

Over 1000 mechanics are ready to answer your question.
The statements expressed above are only for informational purposes and should be independently verified. Please see our terms of service for more details

Ask a Mechanic
(100% Free)

Have a car question? Get free advice from our top-rated mechanics.

Ask A Mechanic
Over 10,000 questions answered!

Get an instant quote for your car

Our certified mechanics come to you ・Backed by 12-month, 12,000-mile guarantee・Save up to 30%

Get a quote

What others are asking

Q: Car in park shifter will move through gears but wont shift through the gears its stuck in neutral have emergency brake on so it wont roll

From what you've described, it sounds like the shifter cable came off at the transmission or the shifter. I'd suggest checking the shift linkage on the transmission to see if the cable came off. This is due to the connector...

Q: Tranny erratic shift if the problem is in the tcm would it throw a faulty tcm code ?or not all the times this happens.

Hello and thank you for contacting Your Mechanic. The code P0760 means that the shift solenoid "C" is operating irregularity. The code P0870 means that the transmission fluid pressure is not determined at its specified pressure. Check the harness to...

Q: Grating/Scraping noise when turning wheel sharp while in reverse

Hey there, thank you for asking about your 2012 Toyota Corolla. This is often times a common issue on cars with what are called "constant velocity" joints (CV joints) when they are not lubricated enough or have dirt and debris...

Related articles

How to Renew Your Car Registration in Oklahoma(DELETED)
Having your car registered with the Oklahoma Tax Commission is an important part of driving legally in this state. You will need to do this within 30 days of moving to Oklahoma...
P2428 OBD-II Trouble Code: Exhaust Gas Temperature Too High Bank 1
P2428 code definition A P2428 trouble code signifies that the PCM has detected a problem in the exhaust gas temperature sensor circuit in bank 1, which subsequently contains the number one...
P2103 OBD-II Trouble Code: Throttle Actuator Control Motor Circuit High
P2103 means there is a fault with the throttle actuator control motor circuit, likely due to a defective electrical component or part.