Q: Engine dies

asked by on March 04, 2017

When i let off the gas pedal the engine dies

Fuel Pump Replacement $120.92 - $1182.22 Get a Quote
Fuel Pressure Regulator Replacement $111.64 - $903.72 Get a Quote

Hi There, It sounds like you may have a fuel supply problem in getting the proper amount of fuel to the fuel injectors. As you know, when you turn the key to on, the fuel pump is activated and the fuel system is primed with fuel at a specific pressure in order to supply the fuel injectors with enough fuel to start the motor. When this is less than what is needed in order for the motor to fire or in some cases higher than normal, you may notice an erratic fluctuation in engine RPMs, hard starting or a lack of power when accelerating as the engine may be starved for fuel if insufficient fuel pressure exists in the fuel system. This can happen when the pump itself is not working properly or when the fuel pressure regulator is not maintaining the proper fuel pressure in the fuel system causing the engine to starve for fuel. This can also happen when there is insufficient connectivity to the fuel injectors which can cause an intermittent fuel spray pattern into the intake system resulting in a lean fuel condition or the motor otherwise starving for fuel. I would recommend having an expert from YourMechanic come to your location to diagnose your fuel system.

The statements expressed above are only for informational purposes and should be independently verified. Please see our terms of service for more details

Get an instant quote for your car

Our certified mechanics come to you ・Backed by 12-month, 12,000-mile guarantee・Fair and transparent pricing

What others are asking

Can u give me a rough estimate for replacing inner and outer tie rod ends on my tundra 2006 sr5?

Hi there. Although the creaking noise might be caused by a tie rod wearing out, it's also possible that another steering system or suspension component is faulty and causing the noise. You might want to have one of our mobile...

2014 Ford Focus Blower Resistor Location

If you have Electronic Manual Temperature Control (EMTC), the blower motor resistor block is accessed by removing the accelerator pedal. Once the pedal is removed you will see the wiring harness to the block and the single retaining screw that...

How do I use the ParkView rear back up camera?

The ParkView rear back up camera gives you extra vision when backing up. The camera is located on the rear of the vehicle, to the left of the trailer hitch. When you put your car in REVERSE, the ParkView system...

Can a blown bulb cause a short in the circuit resulting in a drained battery overnight ? Mercedes Benz

Hello - no, I don't think it's possible for a light bulb to cause a dead battery unless it's left on overnight. Something else is going on here that's draining your battery. This problem can be diagnosed by connecting an...

No throttle response

If the vehicle was severely overheating, the heat could have damaged components including key sensors. At the same time the loss of power is diagnosed, or once there is a diagnosis, obviously the cause of the overheating has to be...

Transmission slips if I shut truck off and restart it will do fine for a few seconds then slip again

Hi there, thanks for writing in. The reason is starts slipping at 30 is this is where it needs to change to second gear or third gear. The problem is most likely the servo piston for the second gear engagement...

What do I need for a tune up on a 2004 c240

Hi Adele. Thanks for contacting us today. One of the best tools we have on our website is the service maintenance schedule. By clicking this link and entering your vehicle information, you can access the recommended scheduled maintenance based on...

Car will not start new battery

You will need to have battery fully charged and then have charging system tested. If jump starting the car does not let the engine start then you may have a starter or theft system problem and would need further tests...

Ac blows hot in summer heat blows cool in winter

I can understand your confusion and frustration, I believe your Kia is experiencing a few different issues that could all together duplicate the concerns you are experiencing. It would appear that one or more blend doors, these are inside the...

Related articles

P2780 OBD-II Trouble Code: Downshift Switch Circuit Low
P2780 means that the PCM has found an issue with the downshift switch circuit’s electrical circuit due to damaged, corroded, or shorted wiring.
How to Buy a Good Quality Engine Mount
Engine Engine mounts, also called motor mounts, are crucial to your vehicle’s proper functioning; providing a strong grip upon the engine is part of what makes the vehicle function as the damage that would certainly disable the engine if the...
How Long Does a Wheel Speed Sensor Last?
With With all of the sensors and switches that a card has, it can be very overwhelming when trying to keep up with them all. For the most part, a person will become quite familiar with the way that their...