Q: Convertible top stuck

asked by on

The convertible top is half up. It won't close all the way. The top part is down, but the trunk part is not closing completely.

The hydraulic system that moves the top may have a leak or has taken in air and needs to be bled. When this happens, the pump continues to make noise, but the top stops moving. Have an automotive technician inspect the vehicle and verify the concern.

Was this answer helpful?
The statements expressed above are only for informational purposes and should be independently verified. Please see our terms of service for more details
  1. Home
  2. Questions
  3. Convertible top stuck

Get an instant quote for your car

Our certified mechanics come to you ・Backed by 12-month, 12,000-mile guarantee・Fair and transparent pricing

Get a quote

What others are asking

Q: Convertible top doesn't work

Hello. If these both stopped working at the same time then you may have a bad connection. I have had the top on this vehicle end up causing some broken wiring due to contact with the harness. I typically have...

Q: P0008 error code is shown

The P0008 code you are receiving is telling you the camshafts and the crankshaft are reading that they are out of sync. The computer will run tests on the alignment of the camshafts to each other, and with the crankshaft....

Q: Q: What's wrong with my car

The oil light will come on if the oil pressure drops too low for adequate lubrication of moving parts in the engine. If the light does come on, you should quickly shut off the engine, but only once you are...

Related articles

What Causes Hoses to Leak?
While the largest part of your engine is mechanical, hydraulics plays a significant role. You’ll find fluids at work in a number of different areas. Your car's fluids include: Engine oil Transmission...
How Long Does a Distributor O Ring Last?
The distributor is part of the ignition system in your vehicle and its purpose is to route high voltage from the ignition coil to the spark plug. The spark plug then...
P2103 OBD-II Trouble Code: Throttle Actuator Control Motor Circuit High
P2103 means there is a fault with the throttle actuator control motor circuit, likely due to a defective electrical component or part.