Q: Car won't start up tried jumping it it will turn over but die down shortly after

From your description of loose and cracked mounts it sounds like both of the mounts in question should be replaced. However, I would recommend you have a certified mechanic inspect the condition of the mounts and replace (https://www.yourmechanic.com/services/engine-mount-replacement) any that...

From the information provided about your Saturn L300 it appears that oil and coolant are indeed mixing and this is not a good thing. Usually when oil and coolant mix, this is an indication of a leaking or blown head...

I've got videos to replace leaking power steering (https://www.youtube.com/watch?v=l1boEHtawcM) so watch those. If you want to find where the leak is coming from, it is very easy to do on a power steering. All you've got to do is get...

This suggests that the relay may be supplying power to the blower motor regardless of turning the switch off. The blower motor relay (https://www.yourmechanic.com/services/blower-motor-relay-replacement) supplies power to this motor when you turn the switch to "on" that can sometimes fail....

Hi there. If the engine is not starting, then check the battery and make sure that the battery cables (https://www.yourmechanic.com/services/service-battery-cables) are tight and clean. Check the wires on the starter and see if they are tight and clean. Then scan...

Hi there. There is currently no legal method to disable the airbag system in your vehicle. I understand the situation with the recalls being broadcast via the news and social media. However, the manufacturers are all working on the concern...

Hello - the P0420 code (https://www.yourmechanic.com/article/p0420-obd-ii-trouble-code-catalyst-system-efficiency-below-threshold-bank-1-by-jamahl-walker) means the catalytic converter has lost it's ability to burn residual fuel. This could be due to an engine condition that has clogged the catalyst, or a failing oxygen sensor that is not adequately...

The low fluid sensor is mounted inside the washer tank. The sensor may have been contaminated with different typed of cleaning fluids or contacts blocked with debris. I would recommend cleaning out washer tank and sensor to see if this...

Depending on if you have rear drum or disc brakes the noise is usually caused by a warped surface of the rotor or drum. The mechanic may have took off the rear drum to inspect the brakes and knocked out...