Q: Car stalling since EGR valve replacement

asked by on

The car has been stalling ever since, I put a new EGR valve on.

You may have a bad EGR valve or it may be stuck open. Sometimes you can push on the rubber diaphragm on the EGR valve and it will free it up. I would recommend having a technician come out and inspect for vacuum leaks and check the new EGR valve to see if it is operating correctly.

Was this answer helpful?
The statements expressed above are only for informational purposes and should be independently verified. Please see our terms of service for more details
  1. Home
  2. Questions
  3. Car stalling since EGR valve replacement

Get an instant quote for your car

Our certified mechanics come to you ・Backed by 12-month, 12,000-mile guarantee・Fair and transparent pricing

Get a quote

What others are asking

Q: The car stalls occasionally as if the fuel is not been pumped

It sounds like you may have a fuel supply issue that corresponds to the load put on the motor when you turn the A/C on. This may be related to a faulty MAP sensor. The Manifold Absolute Pressure (MAP) sensor...

Q: Check engine light, loss of acceleration, 1 RMP even though stopped, speedometer gauge not working

Sounds like you have done a lot of work on your van recently. It sounds like your vehicle went into failsafe mode causing it to lose power. My suggestion is to have a mechanic, like one from YourMechanic, come and...

Q: Car hesitates, stalls at idle, P0102 code

Hello. This can be caused by a number of things. I usually install a scan tool first to see what the sensors are reading. Most of the time this is caused by a leaking intake manifold gasket. This is a...

Related articles

P0052 OBD-II Trouble Code: HO2S Heater Control Circuit High (Bank 2 Sensor 1)
P0052 code definition HO2S Heater Control Circuit High (Bank 2 Sensor 1) What the...
What are the Car Pool Rules in Hawaii?
Hawaii is widely regarded as a land of vacation and relaxation, and as such, its scenic roads and routes are far better known than the state’s freeways. But, as with all...
P2103 OBD-II Trouble Code: Throttle Actuator Control Motor Circuit High
P2103 means there is a fault with the throttle actuator control motor circuit, likely due to a defective electrical component or part.