Showing articles & questions for topic
L6-2.9L

Related questions

Question
Heater hose leak
I recommend that you have a mechanic, like one from YourMechanic, check your vehicle out for you. The mechanic can pressure test the cooling system, and replace any leaking hoses.
Question
Car sluggish and wants to stall in 2nd gear.
Hi there. From your explanation of the problem it sounds like you are experiencing the onset of a transmission failure. A mechanic would drain the fluid from the transmission and inspect it for metal or debris in the fluid which...
Question
Floorboards wet from coolant leak.
There are a few things that could cause a wet floor. A clogged evaporator drain if you are lucky and a leaking heater core if you are not so lucky. To address the leaking coolant, I would have a technician,...
Question
Car runs sluggish after fuel pump replaced.
You need to make sure the filter was installed in the right direction of fuel flow. Fuel filters are designed to filter fuel as it flows from the tank to the fuel injectors, the filter can only flow efficiently in...
Question
Engine revving when I pump the gas
There are a multiple list of components which can cause your issue. Your vehicle is particularly known to have throttle body issues and engine vacuum leaks. A diagnostic needs to be performed with special tools to correctly determine the issue....
Question
brake pedal goes all the way down
I am assuming that once the brake pedal engages the brakes, that the car stops ok. One thing in particular comes to mind and that is seized or binding caliper slides. One piston calipers have to be mounted on slides....
Question
Heater and air not working
Hello. There are several components to the blower motor. While I can't say that it is common, the motor and resistor do fail. Both will cause the blower to stop working, but there are some differences. If the blower works...
Question
Turn signal not working right
Hello. This is a short in the multifunction switch. This switch develops an internal short that causes this to occur. It can be checked with a voltage meter, but this is a common issue. If you need to have this...
Question
Wont start after timing belt replacement
If you are getting fuel and compression, then you need to check to see if you have spark. If you do not have spark then test the ignition system or crankshaft sensor using a scan tool. If your engine was...
Question
Number five cylinder problem
The wiring on older Volvos, such as with your 1996 Volvo 960, can be a little temperamental and have bad connections. If the ignition coil is good but the coil itself is not receiving the electrical signal from the computer,...
Question
What is the average cost to replace o2 sensor b1 for my 2000 s80 Volvo?
Your best bet would be to request our Check Engine Light diagnostic service. This way, the technician will come out to read the code and assess the fault more than just reading the code and picking a part. The fault...
Question
I have a check engine light on
A P0172 rich code does not describe the items you have replaced. I would inspect the fuel pressure regulator for any signs of fuel in the vacuum line. Otherwise you may have clogged catalytic converters. You should feel a steady...
Question
Malfunction of elecrical system
The door has a switch that closes when the door is opened and causes the lights to stay on and the warning to come on. A simple test with a scanner can tell what door is causing it and then...
Question
Car jerks during quick acceleration
You may have a misfire in the engine or low fuel pressure from a bad pump, clogged filter, or both. I recommend having a mechanic test the fuel pressure and volume to see if the fuel pump is meeting specifications....
Question
The car cannot go faster than 3 mph
This could be several different causes. The fuel pump pressure may not be enough. The catalytic convertors may be clogged, the fuel filter may be clogged, or there could be computer sensor issues or throttle problems. Any of these can...
Question
Are the two ignition modules interchangeable?
The two modules should have a part number clearly indicated on the top, if they are the same, then the modules are interchangeable. If there is a suffix A or B or something like that at the end, there may...
Question
Rack and pinion has been replaced three times in three months
Without knowing the specifics, it's hard to say who or what is responsible. I can say that there are some parts rebuilders out there that are turning out some badly inferior products and selling them for very tempting prices. You...

Need a mechanic?

Our certified mobile mechanics make house calls in over 700 U.S. cities. Fast, free online quotes for your car repair.

Get a quote

Post a question and get free advice from our certified mechanics.


Ask a question