Showing articles & questions for topic
5

Whether the check engine light illuminated due to pulling the fuse you refer to will not be known until a mechanic can perform a check engine light diagnostic (https://www.yourmechanic.com/services/check-engine-light-is-on-inspection). During such a diagnostic, a certified mechanic from YourMechanic (https://www.yourmechanic.com) would...

It is possible that this issue only happens at certain RPMs. I would suspect that the ticking sound is either coming from the engines valvetrain or something loose near the clutch area causing a rattle of sorts. I would not...

Hello. The front and the rear locks all use the same relay located in the body control module. If only the front locks do not work then you either have a failure in the module or a circuit issue. The...

Input from the vehicle speed sensor (VSS) is used by the transmission control module (TCM) to calculate shift points, torque converter operation and other transmission functions. Code P0720 stands for Vehicle Speed Sensor circuit malfunction. Typically, this code indicates a...

This may be a sign of low transmission fluid (https://www.yourmechanic.com/services/transmission-fluid-service) or a faulty transmission control solenoid. As you know, automatic transmissions use pressurized hydraulic fluid to change gears. Every time a gear change is required, the car's computer activates a...

The easiest way to remove bug mess and tar from your paint is to lay a pre-treated wipe over the affected area and let it soak. This allows the chemicals to soak in and saturate the tar. Try rinsing off...

Based on the information you provided, it is possible that a failed seal in the turbo is allowing engine oil into the intake. The result would be increases carbon buildup on your DPF (Diesel Particulate Filter). Usually a flashing Check...

Hi there. Typically when you hear a loud noise like you've described when you turn on the AC system, it's caused by damage to the AC compressor. It could be due to the internal bearings wearing out, which would explain...

The trouble codes that you have downloaded have not arisen due to the use, or non-use, of the fuel additive. Code P0841 (https://www.yourmechanic.com/article/p0841-obd-ii-trouble-code-transmission-fluid-pressure-sensor-switch-a-circuit-range-performance-by-valerie-johnston) simply refers to an abnormality in the transmission fluid pressure sensor circuit. Possible causes of that code...

Hi there. If you've never completed this type of repair, I wouldn't recommend attempting it unless you have a few things. First, purchase a service and repair manual for your Mazda 5 as it will give you detailed steps that...

Hello - the blower fan and motor (https://www.yourmechanic.com/question/fan-blower-won-t-work) are way up under the center portion of the dash, requiring the removal of most of the dash. I would highly recommend a blower motor replacement (https://www.yourmechanic.com/services/heater-blower-motor-replacement) by a mobile, professional mechanic,...

When the Check Engine Light (https://www.yourmechanic.com/services/check-engine-light-is-on-inspection) illuminates, it indicates that Diagnostic Trouble Codes(s) have been stored in your car's engine computer. The codes themselves have to be downloaded in order to know where to begin the diagnostic. The most important...

You could have the oil cooler cleaned off with brake cleaner first then dried. After this, then add oil leak detector dye to the engine oil and then drive vehicle a few days and check for oil leaks with a...