Popular questions

Question
weird noise with cold air intake and idle
This is a common symptom of the mass air flow sensor needing to be upgraded due to the increased air intake. The mass air flow sensor operates based upon predetermined stock tuning in the ECM. When the air flow changes,...
Question
my tire presure sensor fault light is on is it still safe to drive or take a 8 hour trip
The tire pressure light may be on for a couple different reasons. The first is you have a tire low on air and would need to have it checked and fixed before going on a trip. If all the tire...
Question
Check engine light code P0876 Transmission Fluid Pressure Sensor / Switch D Circuit Range / Performance
The key here is you are parking on an incline and the code P0876. One of the possible causes is the transmission is low on fluid. The code is for range or performance, and this means that sensor works sometimes...
Question
Starter keeps spinning after Engine is on
It is possible that there could be an issue with your ignition switch. If the ignition switch is stuck in the start position even after the engine has been started, this can cause the starter to continue turning with the...
Question
Why is my brake warning on my dash on?
The brake light is an indicator that is used for many different reasons. The light can be for low fluid levels in the brake master cylinder, ABS backup failure light, parking brake light switch, and the dash test circuit. The...
Question
Don't know what peripheral parts are needed to replace torque converter. 2003 Ford Explorer
Hi there - since removing the transmission (or engine - can be done either way), exposes the rear main crankshaft seal, and the input seal to the transmission these are always a good idea for replacement "while you're in there"....
Question
Need problem associated with EPC and ABS Lights fixed.
The EPC Light is for the electronic throttle body. You need to have a qualified technician check the codes on the computer to determine the problem. You may just have a loose vacuum hose connected to the intake. The ABS...
Question
My 2004 honda accord is making a loud chirping noise. Already replaced belt, tensioner, idler. What could it be
If it is a power steering pump, then the noise should change as you turn the steering wheel from lock to lock. If it is an alternator belt, the noise will likely change as you add or remove electrical loads...
Question
Window won't roll up on one side
Having as much information as possible is extremely helpful when trying to troubleshoot a window that does not roll up all the way. It appears that someone may have started to diagnose your Accord’s window, since we know a part...
Question
Rebuilding double cardan joint
Rebuilding Cardon joints is a challenge to even the most experienced mechanic. If you like puzzles and have a high threshold of frustration, have at it. But there are many companies these days that specialize in rebuilding driveshafts and axles...
Question
White smoke
White smoke from the tail pipe on start up is normal. Your PT Cruiser's exhaust system gets hot and attracts moisture when it cools. Much like the condensation on your windshield in the morning. When you first start your car,...
Question
Car dies on exit ramp coming off interstate
Hello. I will be happy to assist you. I believe the problem you are having could be a result from a faulty mass air flow sensor or a throttle position sensor. Each component heavily inputs on the air fuel ratio of the vehicle....
Question
My car won't start 1999 Ford Escort
Hello - sounds like you have more than one problem here. The battery drain problem can be diagnosed by connecting an ammeter to the positive (red) battery cable, observe the current drain (likely less than 1 amp), then, one at...
Question
2006 Volkswagen Passat 2.0t won't start and has a light on dash board that says parking brake fault
The parking brake fault on this model is typically traced to the switch or a failed mechanism in the caliper due to corrosion. There is a code reader that a mechanic can apply to read any stored parking brake fault...
Question
2006 Mazda 3 makes a hum sound when accelerating. Sound is louder at higher speeds but stops when car is out in neutral and still
Hi there. If the humming sound is coming from your vehicle while it's in gear, then the likely source is the transmission. It is possible that CV joints or wheel bearings might also be the source of your problem, but...
Question
My temp gauge reads low, but I replaced the thermostat.
In order to properly test the cooling system you'll need to test the temperature at the temperature sending unit with a laser temperature tester or something equivalent. You'll also need a scanner to look at the reading to the ECM...
Question
My Mercedes has shredded two belts in a row
Mercedes uses a devilishly complicated automatic tensioner whose life span is about the same as the belt. The tensioner depends on the twisting force of a sleeve of bonded rubber to keep the belt tight, and by the time the...
Question
Car suddenly stops accelerating.
This may be related to a faulty throttle position sensor or potentially a dirty or failing mass air flow sensor. The mass air flow sensor is a unit in the intake system that monitors air intake as it is mixed...
Question
New alternator and battery checks out fine but cars still dying and electrical issues.
Hi, thanks for writing in. It sounds like there may be a problem in the wiring, a faulty connection, or even a control module. It is going to take some diagnostic work to determine exactly where the problem is located....
Question
What does the Maintenance Minder indicator mean?
Your car is equipped with a pretty advanced system designed to help you remember when most of your maintenance services are due. These reminders are shown in the Maintenance Minder on the dash of your car. The Maintenance...
Question
intermittent screeching coming from front right passenger wheel when accelerating above 20mph.
To be safe, check to make sure that you are not having a problem with the engine belt slipping and causing the squealing noise. Also, make sure the metal backing plate behind the rotor is not too close and rubbing...
Question
Which one of my heater hoses is the inlet on my 1999 Ford Ranger
Hello. The inlet hose for your heating system is the hose that goes to the water pump area. The other hose is the outlet. These flush kits will actually work on either one though as it does go through the...
Question
Misfires at high speed on a high way
Hello there, a few common faults will cause your 2004 BMW 540i to have a misfire on acceleration. Without knowing what code the engine is storing I can only offer general advice. Likely causes for the car to misfire like...
Question
Low idle, Stalls dropping into neutral?
This may be related to a dirty or failing idle air control valve. The idle air control valve reads the air intake as it is mixed with fuel prior to being injected into the engine at low speeds and at...