Popular questions

If you have the extra key then try it to see if problem is with the key or the key warning is a theft system issue? You may need to have system reprogrammed by a locksmith or dealer.

In some cases the hose is still usable, in others a kink will damage it and it will need to be replaced. Regardless of the damaged caused to the hose, a kink in a hose will cause adverse effects on...

With a typical spring compressor, it would be difficult to over compress the spring to the point of damaging it so that seems unlikely. Nevertheless, if no other cause is found, you may have to measure the free height of...

Hi There, It sounds like you may have two separate issues going on here. Your fuel tank sending unit is a unit that monitors the fuel level in your tank. When this is not working properly, you may notice erratic...

There are more tests that need to be done before the speed sensor module is replaced. There are about 20 tests that need to be done to verify the number turbine speed sensor is not working properly. These tests are...

Hi there. If you are completing this job for the first time, it's probably a good idea to purchase a service and repair manual for your 2013 Chevrolet Cruze. This will give you step-by-step instructions, including providing you with illustration...

The windshield issue in your car is common enough for many owners to make the same comment. While Nissan does not currently offer any bulletins or recalls about the issue, nor is there any known cause, it is recommended to...

Hi there. Water will sink down in the fuel. Check the air filter to see if it is dirty. On a diesel engine, if the air filter is dirty then the engine will not start. Check to see if your...

This may be a result of a dirty or failing idle air control valve. The idle air control valve reads the air intake as it is mixed with fuel prior to being injected into the engine at low speeds and...

Hi there - the leak you describe could certainly be caused by the transmission input shaft seal. It's also possible that one of the transmission fluid lines to the radiator has failed, or one of the fluid couplings is leaking...

Hello. This is usually caused by either a worn out engine or transmission mount or an issue with a worn out suspension bushing. Either one will allow parts to move when they should be stationary and will cause this noise...

The most common causes of overheating include low coolant level (including that due to leaks), a faulty thermostat, a plugged radiator, a faulty radiator pressure cap, collapsed hoses, non functioning cooling fans, and a faulty water pump or drive belt....

What you are describing sounds like a dirty or failing idle air control valve. The idle air control valve monitors the air intake as it is mixed with fuel prior to being injected into the engine at low speeds and...

Hi, thanks for writing in. This may be a sign of a failing starter relay. The starter relay is a small unit near the starter that directs power to the starter from the battery. When this fails, it may cause...

Hi there. The metal-to-metal sound coming from an engine during acceleration is commonly due to low oil levels. The sound is caused by the valves or cylinder head hardware clanking due to reduced oil pressure or improper lubrication. However, there...

It sounds like you may have some pinched wires or an electrical problem with the wiring running through the doors to the drive's side of the vehicle. As you may know, there are wires that run through the doors that...

If your transmission will not get reverse gear then you may have an internal reverse clutch band worn out or the apply solenoid is not coming on and would need to have transmission pressures and codes checked to isolate the...

There could be a coolant leak on a coolant hose, the radiator, the reservoir, the heater core, or one or more freeze plugs on your engine. It is best to on a pressure tester on your cooling system and check...

Hello. There are a few common issues on this vehicle. Before getting too far into it, I always check to see if there is any aftermarket equipment such as an aftermarket radio. Most of the time, any electronics that are...

The time required varies by vehicle year, make, and model. The required time could range from 1/2 hour to literally hours in some unusual designs. For your particular year, make and model, that is a 2002 Protege, it requires about...

The ESC light indicates that there is a problem with the Electronic Stability Control. Many times this is caused by a failing wheel speed sensor. Have the vehicle scanned and diagnostic trouble codes read to help indicate if a sensor...

The trouble code P0440 means the Evaporative emission control system is malfunction. This malfunction may have been caused by a number of different things including, a loose or missing gas cap, a vacuum leak, a faulty purge valve, an issue...

Hi there - the electrically-assisted steering rack does have a software component that must be loaded, and sync'd with the rest of the car. This will require a visit to your Ford dealer, or Ford service center with this capability....

Hello, thank you for writing in. The rear cup holders that fold out from the back of the center console are not designed to be removed on a regular basis. If you are having issues cleaning the cup holders where...