The master cylinder is likely worn out and should be replaced. The rubber cups simply allow the brake fluid to slip past, rather than compress, when the brake pedal is pressed. I would also replace all of your brake hoses...
The remote control for your car is much more than just a convenient way to lock or unlock the doors from afar. It also offers enhanced personal safety through the Panic button. Pressing the Panic button automatically sets off the...
Hello there. We'd be happy to provide you with a price estimate to have one of our professional mobile mechanics come to your location and complete a water pump replacement. In order to do so, we need to collect a...
When the code P0700 is set in the Powertrain Computer, it means that the Powertrain Computer or PCM is seeing greater than a specified RPM difference between the rotational speed of the Input RPM Sensor and the Transmission Output RPM...
Hello, thank you for writing in. It is possible the shifter cable or its related components are damaged. They are typically visible from the bottom of the transmission. It should not be hard to inspect that area if you can...
It sounds like you might have a vacuum leak at your brake booster, or maybe the booster itself is bad. The booster uses engine vacuum to assist the brake pedal so when it fails, you can get a vacuum leak,...
You should first check the bulb by swapping bulbs from one side to the other to see if you have a defective bulb. If swapping bulbs do not work then you need to check light socket wires are getting power...
Check for a vacuum leak on the engine. A vacuum leak will cause the engine to rough rough and stall out when the engine is cold or hot. If there is no vacuum leak, then the Mass Air Flow Sensor...
Hello. No spark for an entire bank, or side of the engine, can be caused by a few different things. If cylinders 1, 3, and 5 are all experiencing the same issue I would consider the possibility of a faulty...
Hello, thank you for writing in. At this point there are a lot of possible causes for your vehicle's symptoms. To gather more information, we need to start with having the vehicle scanned for diagnostic troubleshooting codes. This can be...
Take the 2000 Isuzu Trooper back to the rebuilder since they should have a 12,000 mile 12 month warranty on the repairs. They should honor the warranty for you since your car is under mileage. The possible problem in this...
The belt has to be on the compressor for the system to work. If you haven't already done so, installing a new belt will be a good first step and it may solve all your trouble. But if the air...
If you did not have any issue before the tires were put on and now the problem has appeared, than this indicates that there is tire problems. I would recommend having the tire store put a different brand of tires...
A hard start or stall after starting is most likely caused by a fuel pump that is not holding pressure up to the fuel injectors after you shut off the engine. The fuel pressure should be tested to verify the...
The shifter knob shift mechanism may be loosing contact and needs to be replaced. The switch will need to be tested and monitored using the Mercedes scanner. If the switch gives erratic readings when scanned and while the switch is...
Hello. The engine swap you are inquiring about would require heavy customization, and for this reason is not a service we would be able to provide. The 2JZGTE is a rear wheel drive motor, designed to be longitudinally mounted, and...
This light will usually come on when one of two things are happening. Either the motor is in fact low on oil or the oil pressure sending unit is not working properly and may be producing a faulty reading. I...
Hello there, a few common faults will result in your 2003 Hyundai overheating after the bypass hose was replaced. The most common would be air trapped in the coolant system. This is common after repairs have been performed if the...
Hi there. In order to provide you with an estimate to have your valve cover gasket, we'll need to receive a bit more information about your vehicle and location. Please click this link and then click the Get a Quote...
You need to check to see if the thermostat is opening properly and if the cooling fan came on. The upper and lower hose should be hot if it is open. If this is your first time running the car...
Hello! Being that it would not shift gears at all it could be an issue within the shift linkages. If the transmission was just serviced and you are experiencing transmission issues so soon after, I would take it back to...
Hi There, This is something that usually requires the steering angle sensor to be re-calibrated or replaced. I would suggest having a professional from YourMechanic come to your location to have this done. As you may know, the steering angle...
Hello. It would depend on what actuator solenoid you are talking about. If you are talking about a shift solenoid, mounted on the transmission, then it may be possible that it was damaged when you made contact. If the contact...
